Michael Krufky wrote: > Jonathan Coles wrote: >> Michael Krufky wrote: >>> Devin Heitmueller wrote: >>> >>>> On Sun, Sep 21, 2008 at 10:22 AM, Jonathan Coles >>>> <jcoles0727@xxxxxxxxxx> wrote: >>>> >>>>> It would really help if there was a single set of instructions >>>>> specific >>>>> to the HVR-950 with tests at each stage. I'm really confused as to the >>>>> status of my installation. >>>>> >>>>> I compiled the firmware according to the instructions on >>>>> http://linuxtv.org/repo/. The result: >>>>> >>>>> $ lsusb >>>>> Bus 005 Device 002: ID 2040:7200 Hauppauge >>>>> >>>> Hold the phone! You don't have an HVR-950. You have an HVR-950Q. >>>> Please be sure to mention this in all future messages, since it's a >>>> totally different device and the HVR-950 directions do not apply. >>>> >>>> I'm not sure whether the HVR-950Q support has been merged yet. Steven >>>> could comment on that. I suspect it's still in a separate branch, >>>> which would mean you would need to do an hg clone of a different tree. >>>> >>> >>> HVR950Q ATSC / QAM is supported in the master development repository, >>> and it is in upstream 2.6.26 and later. >>> >>> You need the xc5000 firmware. >>> >>> [ 17.247610] usb 5-2: new high speed USB device using ehci_hcd and >>> address 2 >>> [ 17.380387] usb 5-2: unable to read config index 0 descriptor/all >>> [ 17.380434] usb 5-2: can't read configurations, error -71 >>> >>> >>> ^^ This is not a firmware problem, but looks fishy. If using the >>> latest drivers from linuxtv.org doesnt work for you, then try another >>> USB port, or confirm that it also works in windows. >>> >>> Good Luck, >>> >>> Mike >>> >> Thanks guys! >> >> The box says HVR-950 on it and that the device "Cannot receive digital >> cable TV". However, the device itself is labeled "NTSC/ATSC/QAM HD TV >> receiver" and there is a small, stylized Q following the "950". Great! >> I got this on sale. Lack of QAM support was my reason for not buying >> earlier at the usual price. Perhaps the store didn't realize that this >> is the newer model. >> >> I had added the XC5000 firmware, dvb-fe-xc5000-1.1.fw, in case I had a >> 950Q. But if, as you say, I need a later kernel, that might be why it >> doesn't work. I have kernel 2.6.24-19. >> >> I'll look for more info on linuxtv.org. Perhaps I just need to wait a >> little for the support for this to be developed. > I am telling you that this device is already supported -- You must use > kernel version 2.6.26 or later, *or* you can use the latest modules from > linuxtv.org with your older kernel. > > Check the howto for info about how to install the drivers: > > http://linuxtv.org/repo > > > ...and yes -- your stick does support QAM. Jonathan, this sticks works very nicely for me for ATSC and US digital cable services. I think you'll enjoy it! If you have specific hvr-950q issues perhaps you could generate a new thread with the appropriate subject (for future reference to users with similar issues). Regards, Steve _______________________________________________ linux-dvb mailing list linux-dvb@xxxxxxxxxxx http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb
