Devin Heitmueller wrote: > On Sun, Sep 21, 2008 at 10:22 AM, Jonathan Coles <jcoles0727@xxxxxxxxxx> wrote: >> It would really help if there was a single set of instructions specific >> to the HVR-950 with tests at each stage. I'm really confused as to the >> status of my installation. >> >> I compiled the firmware according to the instructions on >> http://linuxtv.org/repo/. The result: >> >> $ lsusb >> Bus 005 Device 002: ID 2040:7200 Hauppauge > > Hold the phone! You don't have an HVR-950. You have an HVR-950Q. > Please be sure to mention this in all future messages, since it's a > totally different device and the HVR-950 directions do not apply. > > I'm not sure whether the HVR-950Q support has been merged yet. Steven > could comment on that. I suspect it's still in a separate branch, > which would mean you would need to do an hg clone of a different tree. HVR950Q ATSC / QAM is supported in the master development repository, and it is in upstream 2.6.26 and later. You need the xc5000 firmware. [ 17.247610] usb 5-2: new high speed USB device using ehci_hcd and address 2 [ 17.380387] usb 5-2: unable to read config index 0 descriptor/all [ 17.380434] usb 5-2: can't read configurations, error -71 ^^ This is not a firmware problem, but looks fishy. If using the latest drivers from linuxtv.org doesnt work for you, then try another USB port, or confirm that it also works in windows. Good Luck, Mike _______________________________________________ linux-dvb mailing list linux-dvb@xxxxxxxxxxx http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb
