> Thanks for doing that, it appears that the two cards (E800F and E650) > have the same subvendor and product ids. Also the same i2c output... > > So this means that if I make a patch for DVB support in one, it will > automatically be loaded for the other. This however does pose a > dilemma when looking at the analog side of the card. However this can > be hopefully tackled at a later stage. > > The key registers that I'm after are the states of: > VID_A_INT_MSK > VID_B_INT_MSK > VID_C_INT_MSK > > As I need to determine which port has the digital stream connected to > it. > > Typically these are zero when not in use, so if you run the program > when the tuner is not in use then run the DVB program you should see a > change in state of one of these only. > > Can you also tune to an analog channel as well and let me know which > one it is on (a, b or c). > > Thanks, > > Stephen. > > > -- > Be Yourself @ mail.com! > Choose From 200+ Email Addresses > Get a Free Account at www.mail.com Stephen, I managed to install a copy of D-scaler (v4.1.11) which contained regspy from http://www.dscaler.org/downloads.htm, but was unable to get regspy nor d-scaler to recognize the Compro E800 card. Thus I have been unable to get the register dump you requested. I can try again if you think that regspy can be made to work with the card and any suggestions here would be appreciated. Tom _______________________________________________ linux-dvb mailing list linux-dvb@xxxxxxxxxxx http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb
