Aidan Just to let you know that after tweaking around I've managed to get it working stable. I had to add a sleep in modprobe.conf else the em2880-dvb module was trying to load before em28xx had 'settled'. Just in case you see the problem in the future I added this to my modprobe.conf file to fix the problem..... install em28xx /sbin/modprobe --ignore-install em28xx; /bin/sleep 2; /sbin/modprobe em2880-dvb I've been reading that once 2.6.25 kernel is released there will be a lot more support for the em28 products....hopefully it'll reduce some of these issues going forward. Best Regards and once again thanks for your help. J On 03/04/2008, Aidan Thornton <makosoft@xxxxxxxxxxxxxx> wrote: > On 4/3/08, Another Sillyname <anothersname@xxxxxxxxxxxxxx> wrote: > > Hi Aidan > > > > I've played around with this for a few hours now and we have moved > > forward but not quite working yet..... > > > > The card is getting loaded properly (when I use the appropriate > > card=17 option) however loading the em2880-dvb module then borks..... > > > > I've attached the edited dmesg file.....any ideas? > > > > Thanks > > > > J > > > Hi, > > Sorry about that - I forgot to copy over a couple of extra GPIO writes > needed to switch the device to DVB-T mode. (I knew some devices needed > them, I'd just forgotten about it and didn't think to check). Try > again now. > > > Aidan > _______________________________________________ linux-dvb mailing list linux-dvb@xxxxxxxxxxx http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb
