Hi Mauro, On Fri, 2008-03-14 at 17:21 -0300, Mauro Carvalho Chehab wrote: > On Sat, 15 Mar 2008 04:34:34 +0900 > timf <timf@xxxxxxxxxxxx> wrote: > > > > > Now, do two tests, with v4l-dvb tree + the patch: > > Of course, you'll need to compile and install v4l-dvb ;) > make > make install > > > cx88-dvb or saa7134-dvb ? > saa7134-dvb. > > > Cheers, > Mauro This time: 1) new install of ubuntu 7.10 2) mercurial v4l-dvb, patched 3) make, sudo make install 4) in /etc/modprobe.d/options timf@ubuntu:~$ sudo cat /etc/modprobe.d/options [sudo] password for timf: # Enable double-buffering so gstreamer et. al. work options quickcam compatible=2 # Default hostap to managed mode options hostap_pci iw_mode=2 options hostap_cs iw_mode=2 options tuner-xc2028 debug=1 options tuner debug=1 options saa7134 tuner=71 i2c_scan=1 timf@ubuntu:~$ 5) xc3028-v27.fw into /lib/firmware/2.6.22-14-generic sudo chmod 644 xc3028-v27.fw 6) reboot 7) dmesg <snip> [ 14.856000] ACPI: PCI Interrupt 0000:00:05.0[A] -> Link [APC7] -> GSI 16 (level, low) -> IRQ 20 [ 14.856000] PCI: Setting latency timer of device 0000:00:05.0 to 64 [ 14.860000] NVRM: loading NVIDIA UNIX x86 Kernel Module 100.14.19 Wed Sep 12 14:12:24 PDT 2007 [ 14.860000] parport_pc 00:08: reported by Plug and Play ACPI [ 14.860000] parport0: PC-style at 0x378 (0x778), irq 7, dma 3 [PCSPP,TRISTATE,COMPAT,ECP,DMA] [ 14.936000] Linux video capture interface: v2.00 [ 14.952000] usbcore: registered new interface driver xpad [ 14.952000] /build/buildd/linux-source-2.6.22-2.6.22/drivers/input/joystick/xpad.c: driver for Xbox controllers v0.1.6 [ 14.996000] saa7130/34: v4l2 driver version 0.2.14 loaded [ 15.000000] ACPI: PCI Interrupt Link [APC2] enabled at IRQ 17 [ 15.000000] ACPI: PCI Interrupt 0000:04:09.0[A] -> Link [APC2] -> GSI 17 (level, low) -> IRQ 21 [ 15.000000] saa7133[0]: found at 0000:04:09.0, rev: 209, irq: 21, latency: 32, mmio: 0xfdbff000 [ 15.000000] saa7133[0]: subsystem: 1461:f936, board: AVerMedia Hybrid TV/Radio (A16D) [card=137,autodetected] [ 15.000000] saa7133[0]: board init: gpio is 2fa00 [ 15.168000] saa7133[0]: i2c eeprom 00: 61 14 36 f9 00 00 00 00 00 00 00 00 00 00 00 00 [ 15.168000] saa7133[0]: i2c eeprom 10: ff ff ff ff ff 20 ff ff ff ff ff ff ff ff ff ff [ 15.168000] saa7133[0]: i2c eeprom 20: 01 40 01 02 02 01 01 00 08 ff 00 0e ff ff ff ff [ 15.168000] saa7133[0]: i2c eeprom 30: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff [ 15.168000] saa7133[0]: i2c eeprom 40: ff 65 00 ff c2 1e ff ff ff ff ff ff ff ff ff ff [ 15.168000] saa7133[0]: i2c eeprom 50: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff [ 15.168000] saa7133[0]: i2c eeprom 60: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff [ 15.168000] saa7133[0]: i2c eeprom 70: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff [ 15.168000] saa7133[0]: i2c eeprom 80: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff [ 15.168000] saa7133[0]: i2c eeprom 90: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff [ 15.168000] saa7133[0]: i2c eeprom a0: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff [ 15.168000] saa7133[0]: i2c eeprom b0: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff [ 15.168000] saa7133[0]: i2c eeprom c0: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff [ 15.168000] saa7133[0]: i2c eeprom d0: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff [ 15.168000] saa7133[0]: i2c eeprom e0: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff [ 15.168000] saa7133[0]: i2c eeprom f0: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff [ 15.184000] saa7133[0]: i2c scan: found device @ 0xa0 [eeprom] [ 15.196000] saa7133[0]: i2c scan: found device @ 0xc2 [???] [ 15.296000] tuner' 2-0061: Setting mode_mask to 0x0e [ 15.296000] tuner' 2-0061: chip found @ 0xc2 (saa7133[0]) [ 15.296000] tuner' 2-0061: tuner 0x61: Tuner type absent [ 15.304000] tuner' 2-0061: switching to v4l2 [ 15.304000] tuner' 2-0061: tv freq set to 400.00 [ 15.304000] tuner' 2-0061: tuner type not set [ 15.304000] tuner' 2-0061: tv freq set to 400.00 [ 15.304000] tuner' 2-0061: tuner type not set [ 15.304000] saa7133[0]: registered device video0 [v4l2] [ 15.304000] saa7133[0]: registered device vbi0 [ 15.304000] saa7133[0]: registered device radio0 [ 15.304000] tuner' 2-0061: Cmd TUNER_SET_STANDBY accepted for analog TV [ 15.332000] saa7134 ALSA driver for DMA sound loaded [ 15.332000] saa7133[0]/alsa: saa7133[0] at 0xfdbff000 irq 21 registered as card -2 [ 15.392000] ACPI: PCI Interrupt Link [AAZA] enabled at IRQ 22 [ 15.392000] ACPI: PCI Interrupt 0000:00:10.1[B] -> Link [AAZA] -> GSI 22 (level, low) -> IRQ 17 [ 15.392000] PCI: Setting latency timer of device 0000:00:10.1 to 64 <snip> 7) lsmod <snip> loop 19076 0 snd_hda_intel 263712 1 saa7134_alsa 15648 0 snd_pcm_oss 44672 0 snd_mixer_oss 17664 1 snd_pcm_oss tuner 27724 0 tea5767 8324 1 tuner tda8290 14340 1 tuner tda18271 31880 1 tda8290 tda827x 11396 1 tda8290 tuner_xc2028 22288 1 tuner xc5000 11396 1 tuner tda9887 12036 1 tuner tuner_simple 14092 1 tuner tuner_types 14976 1 tuner_simple mt20xx 13704 1 tuner tea5761 6276 1 tuner snd_pcm 80388 3 snd_hda_intel,saa7134_alsa,snd_pcm_oss snd_seq_dummy 4740 0 snd_seq_oss 33152 0 snd_seq_midi 9600 0 snd_rawmidi 25728 1 snd_seq_midi snd_seq_midi_event 8448 2 snd_seq_oss,snd_seq_midi snd_seq 53232 6 snd_seq_dummy,snd_seq_oss,snd_seq_midi,snd_seq_midi_event snd_timer 24324 2 snd_pcm,snd_seq snd_seq_device 9228 5 snd_seq_dummy,snd_seq_oss,snd_seq_midi,snd_rawmidi,snd_seq saa7134 142676 1 saa7134_alsa snd 54660 12 snd_hda_intel,saa7134_alsa,snd_pcm_oss,snd_mixer_oss,snd_pcm,snd_seq_oss,snd_rawmidi,snd_seq,snd_timer,snd_seq_device xpad 9988 0 videodev 34432 2 tuner,saa7134 v4l1_compat 16004 1 videodev compat_ioctl32 2304 1 saa7134 v4l2_common 12672 2 tuner,saa7134 videobuf_dma_sg 14724 2 saa7134_alsa,saa7134 videobuf_core 19460 2 saa7134,videobuf_dma_sg ir_kbd_i2c 11280 1 saa7134 soundcore 8800 1 snd ir_common 38404 2 saa7134,ir_kbd_i2c parport_pc 37412 1 nvidia 6221648 34 snd_page_alloc 11400 2 snd_hda_intel,snd_pcm psmouse 39952 0 serio_raw 8068 0 tveeprom 13572 1 saa7134 i2c_nforce2 7040 0 parport 37448 3 ppdev,lp,parport_pc pcspkr 4224 0 agpgart 35016 1 nvidia k8temp 6656 0 i2c_core 26112 17 tuner,tea5767,tda8290,tda18271,tda827x,tuner_xc2028,xc5000,tda9887,tuner_simple,mt20xx,tea5761,saa7134,v4l2_common,ir_kbd_i2c,nvidia,tveeprom,i2c_nforce2 shpchp 34580 0 pci_hotplug 32704 1 shpchp evdev 11136 4 <snip> 8) The chip on my card is xc3018. Why does module xc5000 load? Regards, Tim _______________________________________________ linux-dvb mailing list linux-dvb@xxxxxxxxxxx http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb