Hi all, A while back I reported I was having problems with compiling drivers for a HVR-1250. I got the drivers compiled recently using the latest source from v4l-dvb. I saw that cx23885 loaded and detected the card ok, so I tried watching video in mythtv, to no avail. I then tried dumping /dev/dvb/adaptor0/dvr0 to a file and got something 0KB in size. Also using azap, I don't get a lock... But the card seems to be loading drivers ok. the output of "dmesg |grep cx" gives the following: [ 1230.386126] cx23885 driver version 0.0.1 loaded [ 1230.386186] CORE cx23885[0]: subsystem: 0070:7911, board: Hauppauge WinTV-HVR1250 [card=3,autodetected] [ 1230.487835] cx23885[0]: i2c bus 0 registered [ 1230.487852] cx23885[0]: i2c bus 1 registered [ 1230.487863] cx23885[0]: i2c bus 2 registered [ 1230.514568] cx23885[0]: warning: unknown hauppauge model #0 [ 1230.514569] cx23885[0]: hauppauge eeprom: model=0 [ 1230.514571] cx23885[0]: cx23885 based dvb card [ 1230.575799] DVB: registering new adapter (cx23885[0]) [ 1230.575944] cx23885_dev_checkrevision() Hardware revision = 0xb0 [ 1230.575950] cx23885[0]/0: found at 0000:03:00.0, rev: 2, irq: 17, latency: 0, mmio: 0xfd000000 So It looks like the card should be working. However, the output of azap shows: using '/dev/dvb/adapter0/frontend0' and '/dev/dvb/adapter0/demux0' tuning to 677028615 Hz video pid 0x0031, audio pid 0x0034 status 00 | signal 0082 | snr 0087 | ber 00000000 | unc 00000000 | status 00 | signal 0087 | snr 0087 | ber 00000000 | unc 00000000 | status 00 | signal 007d | snr 007d | ber 00000000 | unc 00000000 | status 00 | signal 0082 | snr 0082 | ber 00000000 | unc 00000000 | status 00 | signal 0087 | snr 0087 | ber 00000000 | unc 00000000 | status 00 | signal 0082 | snr 0082 | ber 00000000 | unc 00000000 | and so on. I never get FE_HAS_LOCK, which seems to mean that my tuner can't actually change channels or tune a particular one...? The next thing I tried was upgrading my kernel to 2.6.24, because I read that the HVR-1250 is supported in this kernel. However, still no luck, and I get the same output of azap and can't seem to watch TV. I'm stumped at this point, can anyone see what I'm doing wrong? Cheers, Raphael _______________________________________________ linux-dvb mailing list linux-dvb@xxxxxxxxxxx http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb
