The driver in linux kernel 2.6.24.2 for "Terratec Cinergy DT usb XS diversity" sets the reported bandwith outside the fe_bandwidth_t range. The value 0 (BANDWIDTH_8_MHZ) is replaced with 8000. Here is an example showing the problem... Device: Terratec Cinergy DT usb xs diversity Linux: 2.6.24.2 (modules: mt2266, dvb_usb_dib0700) Firmware: dvb-usb-dib0700-1.10.fw Received event for frontend 0 Status for frontend 0 is now: 0 (no signal) Reported parameters for frontend 0 are now: Frequency: 714000000 Hz Inversion: AUTO (2) Bandwidth: 8 (0) High priority stream code rate: AUTO (9) Low priority stream code rate: AUTO (9) Constellation: QAM64 (3) Transmission mode: AUTO (2) Guard interval: AUTO (4) Hierarchy information: AUTO (4) Received event for frontend 0 Status for frontend 0 is now: FE_HAS_SIGNAL (found something above the noise level) FE_HAS_CARRIER (found a DVB signal) FE_HAS_VITERBI (FEC is stable) FE_HAS_SYNC (found sync bytes) FE_HAS_LOCK (everything's working) Reported parameters for frontend 0 are now: Frequency: 714000000 Hz Inversion: AUTO (2) Bandwidth: ??? (8000) High priority stream code rate: 2/3 (2) Low priority stream code rate: 1/2 (1) Constellation: QAM64 (3) Transmission mode: 8K (1) Guard interval: 1/8 (2) Hierarchy information: NONE (0) _______________________________________________ linux-dvb mailing list linux-dvb@xxxxxxxxxxx http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb
