Hi, I recently acquired a Hauppauge wintv-hvr-1250 PCIe ATSC tuner card and have compiled/installed the latest v4l-dvb drivers ok. (BTW, I'm using an ABIT AN-M2HD motherboard with an AMD 4000+ cpu) I'm not sure which modules are required, but when I load the cx23885 module (via /sbin/modprobe cx23885), I get an error on the tveeprom header. dmesg reports: CORE cx23885[0]: subsystem: 0070:7911, board: Hauppauge WinTV-HVR1250 [card=3,autodetected] cx23885[0]: i2c bus 0 registered cx23885[0]: i2c bus 1 registered cx23885[0]: i2c bus 2 registered tveeprom 4-0050: Encountered bad packet header [ff]. Corrupt or not a Hauppauge eeprom. cx23885[0]: warning: unknown hauppauge model #0 cx23885[0]: hauppauge eeprom: model=0 cx23885[0]: cx23885 based dvb card MT2131: successfully identified at address 0x61 DVB: registering new adapter (cx23885[0]) DVB: registering frontend 0 (Samsung S5H1409 QAM/8VSB Frontend)... cx23885_dev_checkrevision() Hardware revision = 0xb0 cx23885[0]/0: found at 0000:03:00.0, rev: 2, irq: 16, latency: 0, mmio: 0xfce00000 PCI: Setting latency timer of device 0000:03:00.0 to 64 I'm concerned about the tveeprom message -- are there any other modules I need to load for this board? Is there any firmware I'm missing? Thanks, Henry _______________________________________________ linux-dvb mailing list linux-dvb@xxxxxxxxxxx http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb
