On Feb 7, 2008 12:38 PM, Henry Leinhos <henry-list@xxxxxxxxxxx> wrote: > I'm not sure which modules are required, but when I load the cx23885 module > (via /sbin/modprobe cx23885), I get an error on the tveeprom header. dmesg > reports: > > CORE cx23885[0]: subsystem: 0070:7911, board: Hauppauge WinTV-HVR1250 > [card=3,autodetected] > cx23885[0]: i2c bus 0 registered > cx23885[0]: i2c bus 1 registered > cx23885[0]: i2c bus 2 registered > tveeprom 4-0050: Encountered bad packet header [ff]. Corrupt or not a > Hauppauge eeprom. > cx23885[0]: warning: unknown hauppauge model #0 > cx23885[0]: hauppauge eeprom: model=0 > cx23885[0]: cx23885 based dvb card > MT2131: successfully identified at address 0x61 > DVB: registering new adapter (cx23885[0]) > DVB: registering frontend 0 (Samsung S5H1409 QAM/8VSB Frontend)... > cx23885_dev_checkrevision() Hardware revision = 0xb0 > cx23885[0]/0: found at 0000:03:00.0, rev: 2, irq: 16, latency: 0, mmio: > 0xfce00000 > PCI: Setting latency timer of device 0000:03:00.0 to 64 > > > I'm concerned about the tveeprom message -- are there any other modules I > need to load for this board? Is there any firmware I'm missing? Don't worry about the tveeprom error message -- we know why it is happening, and a fix will probably be committed for it relatively soon. For your card, the error has absolutely no influence on the operation of the device. The linux driver currently only supports ATSC / QAM digital tv on your board, you do not need any firmware for this functionality. Regards, Mike _______________________________________________ linux-dvb mailing list linux-dvb@xxxxxxxxxxx http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb
