Hi ! I still have trouble with DiseqC on skystar2 card using b2c2-flexcop-pci driver. No DiseqC or tone_burst works. The plain 22kHz signal is beeing sent, so switching to the hi-band works. It seems that every message sent out by the card isn't understood by the DiseqC switch. I assume the message is sent out, but due to a timing problem the receiver , e.g. switch, cannot detect it. I'm using a recent version of cvs v4l-dvb software with kernel 2.6.23.8 . The card works fine within an windoze system, thus I assume, the hardware and cabling are right. Are there some suggenstions? Thanks a lot Mike _______________________________________________ linux-dvb mailing list linux-dvb@xxxxxxxxxxx http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb
