garlicdevel@xxxxxxxxxxxx wrote:
>> Are you sure you have changed line 405 in pctv452e.c from
>> { STB0899_I2CRPT , 0x5e }, // 0x2c
>> to
>> { STB0899_I2CRPT , 0x58 },
>> as register 0xf12a is STB0899_I2CRPT and 0x5c should not appear there.
> ? (this is not included in my posted patch)
> ?
> ?
> ? Dominik
>
> The windows driver seems to set the initial value to 5c when dumping all registers across initially (on device plug in)
> it then seems to change things later on for tuning purposes
This value comes in from a resistor pullup with regards to the STB0899 to avoid
ringing on the remote I2C bus.This happens to be very much device specific, in
fact i haven't seen no two devices having the same value. The default value
(0x5c) is calculated with a resistance of 3kE and 47pF on Pin16 of the STB0899
Large a value will "dampen" the signal, too small a value will cause "ringing". In
the case of the KNC1 card i was able to calculate it out since the vendor was
helpful (Eventhough i had done this manually the hard way even before they
could get back)
Well, the STB0899 has too many fine strings to be finely tuned for a specific device.
This is similar to other demods, but due to the larger number of registers, there are
even more of those "fine threads".
Manu
_______________________________________________
linux-dvb mailing list
linux-dvb@xxxxxxxxxxx
http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb
