Dear All:
Could you give me some idea?
Right now, I'm working on an ARM926 Platform, and my linux kernel is
2.6.19.2.
the following is my kernel message and I put the firmware in
/usr/lib/hotplug/firmware
================================================================
usbcore: registered new interface driver usbfs
usbcore: registered new interface driver hub
usbcore: registered new device driver usb
fsl-ehci fsl-ehci.0: Freescale On-Chip EHCI Host Controller
fsl-ehci fsl-ehci.0: new USB bus registered, assigned bus number 1
fsl-ehci fsl-ehci.0: irq 54, io base 0x10024200
fsl-ehci fsl-ehci.0: USB 2.0 started, EHCI 1.00, driver 10 Dec 2004
usb usb1: configuration #1 chosen from 1 choice
hub 1-0:1.0: USB hub found
hub 1-0:1.0: 1 port detected
usb 1-1: new full speed USB device using fsl-ehci and address 2
usb 1-1: not running at top speed; connect to a high speed hub
usb 1-1: configuration #1 chosen from 1 choice
dvb-usb: found a 'Hanftek UMT-010 DVB-T USB2.0' in cold state, will try to load
a firmware
dvb-usb: did not find the firmware file. (dvb-usb-umt-010-02.fw) Please see linu
x/Documentation/dvb/ for more details on firmware-problems. (-2)
dvb_usb_umt_010: probe of 1-1:1.0 failed with error -22
usbcore: registered new interface driver dvb_usb_umt_010
================================================================
where do I miss and what should I do to make this one work on my arm
platform?
BTW, which dvb-t usb stick is the best one on arm platform?
Thank you very much.
Best Regards,
Akio
_______________________________________________
linux-dvb mailing list
linux-dvb@xxxxxxxxxxx
http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb
