Hi. (sorry about bad English, if you don't understand something I'm telling, just ask ;) I have a Asus Tiger DVB-T card (got it when I bought this used computer..). lspci says "Philips Semiconductors SAA7133/SAA7135 Video Broadcast Decoder (rev d1)" and if I don't give any modprobe options, my system recognices it (dmesg: saa7133[0]: subsystem: 1043:4857, board: ASUSTeK P7131 Dual [card=78,autodetected]). But I just can't get it to actually work. I mostly try to scan the channels with Kaffeine. I've tried different card=xx tuner=xx compinations etc. And I have also tried to change tuner_config values in my saa7134-cards.c and caa7134-dvb.c (I downloaded the latest sources). Right now Kaffeine shows 45% signal, but it doesn't start to scan the channels (the status indicator just says 0% and terminal says "Invalid section length or timeout: pid=17 Invalid section length or timeout: pid=0". Sometime I had quite good signal (60-70%) and scanning did work, but Kaffeine still couldn't find any channels. And sometimes Kaffeine shows signal only when it scans the first line from my source file. I have tried scan/tzap also, but they don't find anything. dmesg |grep -i saa7 : saa7130/34: v4l2 driver version 0.2.14 loaded saa7133[0]: found at 0000:02:05.0, rev: 209, irq: 22, latency: 32, mmio: 0xf6006000 saa7133[0]: subsystem: 1043:4857, board: ASUSTeK P7131 Dual [card=78,autodetected] saa7133[0]: board init: gpio is 0 input: saa7134 IR (ASUSTeK P7131 Dual) as /class/input/input7 saa7133[0]: i2c eeprom 00: 43 10 57 48 54 20 1c 00 43 43 a9 1c 55 d2 b2 92 saa7133[0]: i2c eeprom 10: ff ff ff 0f ff 20 ff ff ff ff ff ff ff ff ff ff saa7133[0]: i2c eeprom 20: 01 40 01 02 03 01 01 03 08 ff 00 b6 ff ff ff ff saa7133[0]: i2c eeprom 30: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff saa7133[0]: i2c eeprom 40: ff 21 00 c2 96 10 03 32 15 00 ff ff ff ff ff ff saa7133[0]: i2c eeprom 50: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff saa7133[0]: i2c eeprom 60: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff saa7133[0]: i2c eeprom 70: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff saa7133[0]: i2c scan: found device @ 0x10 [???] saa7133[0]: i2c scan: found device @ 0x96 [???] saa7133[0]: i2c scan: found device @ 0xa0 [eeprom] tuner 1-004b: chip found @ 0x96 (saa7133[0]) saa7133[0]: registered device video0 [v4l2] saa7133[0]: registered device vbi0 saa7133[0]: registered device radio0 DVB: registering new adapter (saa7133[0]). dmesg |grep -i firmw (don't know what's with the ten line..) : tda1004x: found firmware revision 20 -- ok tda1004x: found firmware revision 20 -- ok tda1004x: found firmware revision 20 -- ok tda1004x: found firmware revision 20 -- ok tda1004x: found firmware revision 20 -- ok tda1004x: found firmware revision 20 -- ok tda1004x: found firmware revision 20 -- ok tda1004x: found firmware revision 20 -- ok tda1004x: found firmware revision 20 -- ok tda1004x: found firmware revision 20 -- ok fi-Alajarvi (the source file): T 642000000 8MHz 2/3 NONE QAM64 8k 1/8 NONE T 730000000 8MHz 2/3 NONE QAM64 8k 1/8 NONE T 578000000 8MHz 2/3 NONE QAM64 8k 1/8 NONE scan fi-Alajarvi: scanning fi-Alajarvi using '/dev/dvb/adapter0/frontend0' and '/dev/dvb/adapter0/demux0' initial transponder 642000000 0 2 9 3 1 2 0 initial transponder 730000000 0 2 9 3 1 2 0 initial transponder 578000000 0 2 9 3 1 2 0 >>> tune to: 642000000:INVERSION_AUTO:BANDWIDTH_8_MHZ:FEC_2_3:FEC_AUTO:QAM_64:TRANSMISSION_MODE_8K:GUARD_INTERVAL_1_8:HIERARCHY_NONE WARNING: filter timeout pid 0x0011 WARNING: filter timeout pid 0x0000 WARNING: filter timeout pid 0x0010 >>> tune to: 730000000:INVERSION_AUTO:BANDWIDTH_8_MHZ:FEC_2_3:FEC_AUTO:QAM_64:TRANSMISSION_MODE_8K:GUARD_INTERVAL_1_8:HIERARCHY_NONE WARNING: >>> tuning failed!!! >>> tune to: 730000000:INVERSION_AUTO:BANDWIDTH_8_MHZ:FEC_2_3:FEC_AUTO:QAM_64:TRANSMISSION_MODE_8K:GUARD_INTERVAL_1_8:HIERARCHY_NONE (tuning failed) WARNING: >>> tuning failed!!! >>> tune to: 578000000:INVERSION_AUTO:BANDWIDTH_8_MHZ:FEC_2_3:FEC_AUTO:QAM_64:TRANSMISSION_MODE_8K:GUARD_INTERVAL_1_8:HIERARCHY_NONE WARNING: >>> tuning failed!!! >>> tune to: 578000000:INVERSION_AUTO:BANDWIDTH_8_MHZ:FEC_2_3:FEC_AUTO:QAM_64:TRANSMISSION_MODE_8K:GUARD_INTERVAL_1_8:HIERARCHY_NONE (tuning failed) WARNING: >>> tuning failed!!! dumping lists (0 services) Done. _______________________________________________ linux-dvb mailing list linux-dvb@xxxxxxxxxxx http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb
