Oliver Endriss wrote: > Sigmund Augdal wrote: >> On Tuesday 17 July 2007 07:45, Oliver Endriss wrote: >>> Oliver Endriss wrote: >>>> Imho the interrupt processing was broken: >>>> - The first I2C interrupt should be used to wake-up the task. >>>> It does not matter that it takes some time until ERR in IIC_STA >>>> will be updated. We don't need it. >>>> - Interrupts must be acknowledged at the end of the ISR. >>>> >>>> @all >>>> Please test the attached patch. >>>> There shouldn't be any unexpected I2C interrupts anymore. >>> Attached is an updated patch which does extended status checking. >> I've tried this patch on a box running 2.6.20 now for about a day and has not >> yet seen any i2c timeouts with it. I have tried to stress the i2c bus a bit >> by starting and stopping capture, retuning and browsing the MMI menus of the >> CAM quite a lot. I did however not see any pattern in when the i2c timeouts >> happened before applying the patch, so I can't possitivly confirm they are >> all gone. > > Ok, patch committed with minor modifications. > > CU > Oliver > Hi Oliver, I just had time to read the mailing list after several weeks and stumbled accross this thread. I have this error: "saa7146_i2c_writeout: timed out waiting for end of xfer". This error occurs with and without the patch, but only on my modded FF Card(TT1500 DVB-S) with 4MB. Any other card works flawlessly in the same comp and the very same PCI slot. I have two other TT1600 DVB-s which are not modded and working just fine. Could the problems be caused by the 4MB-Mod? Have nice weekend. André _______________________________________________ linux-dvb mailing list linux-dvb@xxxxxxxxxxx http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb
