Hi, Andreas Andreas Krause schrieb: > Hi there! > > I have problems to enable the DVB part of the following DVB-S card: > > card=93, "Medion 7134 Bridge #2 [16be:0005]" > > It is exactly the same card as this one (even printed on PCB): > http://www.creatix.de/support/download/gruppe6/CTX929_spec.pdf > > Chipset: > SD1878/SHA, SAA7134HL, TDA10086HT > > #lspci -v > 00:06.0 Multimedia controller: Philips Semiconductors SAA7134/SAA7135HL > Video Broadcast Decoder (rev 01) > Subsystem: Creatix Polymedia GmbH Unknown device 0005 > Flags: bus master, medium devsel, latency 32, IRQ 5 > Memory at ea000000 (32-bit, non-prefetchable) [size=1K] > Capabilities: [40] Power Management version 1 > > #lsmod | grep saa > saa7134 117696 0 > video_buf 23364 1 saa7134 > compat_ioctl32 1376 1 saa7134 > ir_kbd_i2c 8656 1 saa7134 > i2c_core 20480 9 > w83627hf,i2c_isa,eeprom,dvb_usb,dvb_pll,i2c_viapro,tuner,saa7134,ir_kbd_i2c > ir_common 34084 2 saa7134,ir_kbd_i2c > videodev 25952 1 saa7134 > v4l2_common 15904 3 tuner,saa7134,videodev > v4l1_compat 12420 2 saa7134,videodev > > > #dmesg > saa7134[0]: found at 0000:00:06.0, rev: 1, irq: 5, latency: 32, mmio: > 0xea000000 > saa7134[0]: subsystem: 16be:0005, board: Medion 7134 Bridge #2 > [card=93,autodetected] > saa7134[0]: board init: gpio is 0 > saa7134[0]: Medion 7134 Bridge #2: dual saa713x broadcast decoders > saa7134[0]: Sorry, none of the inputs to this chip are supported yet. > saa7134[0]: Dual decoder functionality is disabled for now, use the other > chip. > saa7134[0]: i2c eeprom 00: be 16 05 00 54 20 1c 00 43 43 a9 1c 55 d2 b2 92 > saa7134[0]: i2c eeprom 10: 00 ff 86 0f ff 20 ff 00 01 50 32 79 01 3c ca 50 > saa7134[0]: i2c eeprom 20: 01 40 01 02 02 03 01 00 06 ff 00 21 02 51 96 2b > saa7134[0]: i2c eeprom 30: a7 58 7a 1f 03 8e 84 5e da 7a 04 b3 05 87 b2 3c > saa7134[0]: i2c eeprom 40: ff 24 00 c0 ff 1c 00 ff ff ff fd 79 44 9f c2 8f > saa7134[0]: i2c eeprom 50: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff > saa7134[0]: i2c eeprom 60: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff > saa7134[0]: i2c eeprom 70: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff > saa7134[0]: registered device video0 [v4l2] > saa7134[0]: registered device vbi0 > > > modprobe tda10086 has no effect. > > Kernel and modules are linux-image-2.6.21-1-686_2.6.21-4_i386.deb (current > debian unstable). > > Any other info needed? > > Thanks for your help! > > CU - nak > It should be possible. Tuner and channel decoder are supported (though there is a problem with the DISEQc i need to cross check). But i will need additional information: What is the type of the LNB controller? This an additional chip on the board, possibly in a small package sitting close to an inductor. (might be ISl64xx) Hartmut _______________________________________________ linux-dvb mailing list linux-dvb@xxxxxxxxxxx http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb
