Hi, Zenon Mousmoulas schrieb: > Hi, > > I have a Lifeview FlyDVB Trio PCI card. > > 06:01.0 Multimedia controller: Philips Semiconductors SAA7133/SAA7135 Video Broadcast Decoder (rev d1) > Subsystem: Animation Technologies Inc. LifeView FlyDVB Trio > Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR+ FastB2B- > Status: Cap+ 66MHz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR- > Latency: 32 (21000ns min, 8000ns max) > Interrupt: pin A routed to IRQ 74 > Region 0: Memory at fc402000 (32-bit, non-prefetchable) [size=2K] > Capabilities: [40] Power Management version 2 > Flags: PMEClk- DSI- D1+ D2+ AuxCurrent=0mA PME(D0-,D1-,D2-,D3hot-,D3cold-) > Status: D0 PME-Enable- DSel=0 DScale=1 PME- > > I am running Debian etch (2.6.18-4-686). I have obtained v4l-dvb through Mercurial (tag 5697:015313b16eab ? dated 20070522), replacing /lib/modules/2.6.18-4-686/kernel/drivers/media. I also got rid of the dvb-utils package and installed dvb-apps through Mercurial. > > I have loaded saa7134-dvb with option use_frontend=1. > > I am trying to tune to a DiSeqC 1.0 switch, which takes input from 4 LNBs. The dish/lnb/switch reception works well, I have tested reception of all 4 satellites with another set top box. > > The problem is I can not get diseqc to work. I have tried scan -s X but it always seems to tune to transponders on satellite in position 1 (Hotbird 13E), no matter what. I have also tried tuning directly with other tools (such as dvbtune and VLC) but the result is always the same. I can tune to transponders on Hotbird, no matter what setting I use for diseqc. > > I am wondering if this card and this frontend supports diseqc at all? I have found some older posts in this list which suggest that tda10086 should now work with diseqc, but I am not so sure after all. Perhaps I am doing something wrong, as I am rather new to linux-dvb. Any ideas would be appreciated. > > Thanks, > Z. > > PS: I have also tested the terrestrial frontend, and it works fine. Yes, there is a known problem and a proposed patch. I need to cross check whether this breaks other drivers. Best regards Hartmut _______________________________________________ linux-dvb mailing list linux-dvb@xxxxxxxxxxx http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb
