Hi, I have a Kworld ATSC110 and can not figure out how to choose between the two inputs described on the box as "Digital Antenna" and "UHF/VHF Antenna". Honestly, I'm not quite sure what they mean by that. I'm assuming I could use one to watch Digital/HDTV broadcasts and the other to watch traditional analog broadcasts (but not simultaneously). The "top" input (farthest away from the motherboard-end of the card) seems to do everything. If I plug my cable TV line into it I can get analog and QAM256 channels. If I plug my "rabbit ears" antenna into it, I can get analog and a few HDTV over-the-air channels. I've used MythTV, tvime and mplayer with success on this input. The other input doesn't do anything. I've seen various reports of people saying which input works for what, but I don't know how to actually select between them. I have NOT tried this card in Windows (I do not have Windows) so I'm not sure which input does what in that environment. I'm using Gentoo with the 2.6.20 Kernel and v4l/dvb from mercurial linuxtv sources from a few days ago. Here is what I believe to be the relevant part of dmesg: Linux video capture interface: v2.00 saa7130/34: v4l2 driver version 0.2.14 loaded saa7133[0]: found at 0000:03:04.0, rev: 240, irq: 20, latency: 32, mmio: 0xdfeff800 saa7133[0]: subsystem: 17de:7350, board: Kworld ATSC110 [card=90,autodetected] saa7133[0]: board init: gpio is 100 saa7133[0]: i2c eeprom 00: de 17 50 73 ff ff ff ff ff ff ff ff ff ff ff ff saa7133[0]: i2c eeprom 10: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff saa7133[0]: i2c eeprom 20: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff saa7133[0]: i2c eeprom 30: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff saa7133[0]: i2c eeprom 40: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff saa7133[0]: i2c eeprom 50: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff saa7133[0]: i2c eeprom 60: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff saa7133[0]: i2c eeprom 70: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff tuner 0-0061: chip found @ 0xc2 (saa7133[0]) tuner 0-0061: type set to 68 (Philips TUV1236D ATSC/NTSC dual in) tuner 0-0061: type set to 68 (Philips TUV1236D ATSC/NTSC dual in) saa7133[0]: registered device video0 [v4l2] saa7133[0]: registered device vbi0 nxt200x: NXT2004 Detected DVB: registering new adapter (saa7133[0]). DVB: registering frontend 0 (Nextwave NXT200X VSB/QAM frontend)... nxt2004: Waiting for firmware upload (dvb-fe-nxt2004.fw)... nxt2004: Waiting for firmware upload(2)... nxt2004: Firmware upload complete Thanks in advance for any clues, and thanks for all the hard work that has been put into this project! Paul _______________________________________________ linux-dvb mailing list linux-dvb@xxxxxxxxxxx http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb
