Eric Dujardin wrote: > Hello all, > > I am trying to get my dvb-t stick to work, but I'm having troubles with > frontends. > > First I also have a Skystar-2 PCI adapter which has been working well > for some time, running > kernel 2.6.17 (gentoo). > > The USB stick is an Atopia AT-TV-USB3. It seems to be very close to a > Dibcom reference design. > > I recently built a 2.6.19-r2 kernel for it, added my stick's vid/pid and > managed to load the firmware, > but in the end I had no frontend: > Dec 27 23:33:44 bouleau dvb-usb: no frontend was attached by 'Atopia > AT-TV-USB3' > > At that point my SS-2 was still fine: > Dec 27 23:24:28 bouleau DVB: registering new adapter (FlexCop Digital TV > device). > Dec 27 23:24:28 bouleau b2c2-flexcop: MAC address = 00:d0:d7:0d:f3:09 > Dec 27 23:24:28 bouleau b2c2-flexcop: found the stv0299 at i2c address: 0x68 > Dec 27 23:24:28 bouleau DVB: registering frontend 0 (ST STV0299 DVB-S)... > Dec 27 23:24:28 bouleau b2c2-flexcop: initialization of 'Sky2PC/SkyStar > 2 DVB-S' at the 'PCI' bus controlled by a 'FlexCopIIb' complete > > So I tried this morning's mercury snapshot, which has an enhanced > stk7700p_frontend_attach(), > did make and make install, but now I have no frontend at all. I even > tried to explicitely load > the stv0299 module, with no success: > > Dec 28 16:41:18 bouleau b2c2-flexcop: B2C2 FlexcopII/II(b)/III digital > TV receiver chip loaded successfully > Dec 28 16:41:18 bouleau flexcop-pci: will use the HW PID filter. > Dec 28 16:41:18 bouleau flexcop-pci: card revision 2 > Dec 28 16:41:18 bouleau ACPI: PCI Interrupt 0000:00:09.0[A] -> GSI 17 > (level, low) -> IRQ 17 > Dec 28 16:41:18 bouleau DVB: registering new adapter (FlexCop Digital TV > device). > Dec 28 16:41:18 bouleau b2c2-flexcop: MAC address = 00:d0:d7:0d:f3:09 > Dec 28 16:41:18 bouleau DVB: Unable to find symbol stv0299_attach() Obviously module stv0299 has not been loaded... > I also tried the 20061209 snapshot with the same results. > > I'm not sure if there's a real problem here, of if it's just me not > using the v4l package as it should. > > Some context finally: arch is x86_64, with glibc 2.4-r3 and gcc -v says: > Thread model: posix > gcc version 3.4.6 (Gentoo 3.4.6-r1, ssp-3.4.5-1.0, pie-8.7.9) Try to load the frontend driver before you load the card driver. Oliver -- -------------------------------------------------------- VDR Remote Plugin 0.3.9 available at http://www.escape-edv.de/endriss/vdr/ -------------------------------------------------------- _______________________________________________ linux-dvb mailing list linux-dvb@xxxxxxxxxxx http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb
