Erik Meitner wrote: > Markus Rechberger wrote: > >> On 11/30/06, Erik Meitner <erik@xxxxxxxxxxxxx> wrote: >> >>> Markus Rechberger wrote: >>> >>>> On 11/27/06, Chris Lawrence <lordsutch@xxxxxxxxx> wrote: >>>> >>>>> On 11/27/06, Markus Rechberger <mrechberger@xxxxxxxxx> wrote: >>>>> >>>>>> ok that's just what I thought.. >>>>>> can you retry with the repository on >>>>>> http://mcentral.de/hg/~mrec/v4l-dvb-kernel >>>>>> >>>>> That did it: >>>>> (snip) >>>>> Incidentally, I've had no luck with tvtime since using the v4 >>>>> firmware... there are no obvious error messages in dmesg, but it >>>>> happens after loading the MN_NTSCPAL_A2 firmware: >>>>> >>>>> [ 2811.454000] xc3028_set_std, Loading specific configuration for >>>>> requested mode xc3028_MN_NTSCPAL_A2.i2c.fw >>>>> >>>>> It doesn't hang the system... it just stops and doesn't do anything. >>>>> The same problem occurs with kdetv. >>>>> >>>>> strace shows the freeze to be happening at >>>>> >>>>> ioctl(3, VIDIOC_DQBUF <unfinished ...> >>>>> >>>>> I can ^C out of it, at least. >>>>> >>>>> >>>> And this still works with the old firmware? >>>> (note do not load the dvb/atsc module, once you loaded it analogue TV >>>> will be switched off there's no switching back mechanism implemented >>>> for your device yet) >>>> >>>> Markus >>>> >>> Using the same code and doing "sudo modprobe em28xx i2c_scan=1" I get >>> the exact same result as Chris using firmware V3 or V4. tvtime just >>> hangs and mplayer reports "v4l2: select timeout". >>> Let me know if there is something you need done, tested, etc. >>> >>> Erik >>> >>> >>> >>> >> Can you send me the output after loading the em28xx with reg_debug=2? >> >> modprobe em28xx reg_debug=2 >> >> (try to open a Tv application, close it and send me what it shows up >> in dmesg) >> >> thanks, >> Markus >> > I ran mplayer long enough to report four select timeouts. > Log attached. > > Thanks, > Erik > Excellent. Using the latest http://linuxtv.org/hg/~mrechberger/v4l-dvb-kernel (e49a1bde8c5a) video and tuning work perfect. No audio initially. em28xx-audio is not automatically loaded. When loaded manually I had to run usbaudio_setup.sh after running tvtime. _______________________________________________ linux-dvb mailing list linux-dvb@xxxxxxxxxxx http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb
