Selon Hartmut Hackmann <hartmut.hackmann@xxxxxxxxxxx>: > Hi, all > > First: thanks for testing. > > To sum up: > Things seem to work, right? > Just some comments: > - It should not be necessary to set card and tuner type manually. > - If no dvb devices are created, the reason most probably is that > the saa7134-dvb module is not loaded. This still needs to be done > separately. > - This card needs the external firmware. > - If you don't have an internal sound cable, you will need to load > the saa7134-oss or the saa7134-alsa module and route the sound > in user space as described in the wiki. This does *not* hold for > dvb-t. > - The digital sound processing uses a sample rate of 32kHz, that's > right. > - The card might have a sensitivity issue. The reason is that there > is an external RF amplifier on the board which is not handled by > the driver yet. > > Can i check the patch in? > > Best regards > Hartmut > > _______________________________________________ > linux-dvb mailing list > linux-dvb@xxxxxxxxxxx > http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb > Hi, just about firmware : You can find it at "http://technotrend-online.com/download/software/217/tt_budget_217g.zip"; and NOT at "http://technotrend-online.com/new/217g/tt_budget_217g.zip"; as it 's qpecified in getfirmeware script. regards, Test on Ubuntu : kernel 2.6.15.25-386 [17181001.888000] Linux video capture interface: v2.00 [17181002.008000] saa7130/34: v4l2 driver version 0.2.14 loaded [17181002.008000] ACPI: PCI Interrupt 0000:00:06.0[A] -> GSI 17 (level, low) -> IRQ 177 [17181002.008000] saa7133[0]: found at 0000:00:06.0, rev: 208, irq: 177, latency : 64, mmio: 0xdffff800 [17181002.008000] saa7133[0]: subsystem: 11bd:002f, board: Pinnacle PCTV 310i [c ard=101,autodetected] [17181002.008000] saa7133[0]: board init: gpio is 600c000 [17181002.152000] saa7133[0]: i2c eeprom 00: bd 11 2f 00 54 20 1c 00 43 43 a9 1c 55 d2 b2 92 [17181002.152000] saa7133[0]: i2c eeprom 10: ff e0 60 06 ff 20 ff ff 00 30 8d 2c 25 f1 ff ff [17181002.152000] saa7133[0]: i2c eeprom 20: 01 2c 01 02 02 01 04 31 98 ff 00 a6 ff 21 00 c2 [17181002.152000] saa7133[0]: i2c eeprom 30: 96 10 03 32 15 20 ff ff 0c 22 17 77 03 1c 94 81 [17181002.152000] saa7133[0]: i2c eeprom 40: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff [17181002.152000] saa7133[0]: i2c eeprom 50: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff [17181002.152000] saa7133[0]: i2c eeprom 60: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff [17181002.152000] saa7133[0]: i2c eeprom 70: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff [17181002.248000] tuner 0-004b: chip found @ 0x96 (saa7133[0]) [17181002.296000] tuner 0-004b: setting tuner address to 61 [17181002.336000] tuner 0-004b: type set to tda8290+75a [17181002.400000] saa7133[0]: registered device video0 [v4l2] [17181002.404000] saa7133[0]: registered device vbi0 [17181002.404000] saa7133[0]: registered device radio0 [17181002.428000] saa7134 ALSA driver for DMA sound loaded [17181002.428000] saa7133[0]/alsa: saa7133[0] at 0xdffff800 irq 177 registered a s card -1 [17181107.364000] DVB: registering new adapter (saa7133[0]). [17181107.364000] DVB: registering frontend 0 (Philips TDA10046H DVB-T)... [17181168.276000] tda1004x: setting up plls for 48MHz sampling clock [17181168.544000] tda1004x: found firmware revision 0 -- invalid [17181168.544000] tda1004x: waiting for firmware upload... [17181168.608000] tda1004x: no firmware upload (timeout or file not found?) [17181168.608000] tda1004x: firmware upload failed <--FUNNY !! WHY D'ONT YOU SAY IT BEFORE ;-) P.S. I Need to set up SECAM to L for the "tuner" module (for French TV) ----- Fin du message transféré ----- _______________________________________________ linux-dvb mailing list linux-dvb@xxxxxxxxxxx http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb
