Hi! I am using a Freecom DVB-T usb device which has the usb id 14aa:0225 before the driver / firmware is loaded. My system is gentoo linux with 2.6.17-gentoo-r8 kernel source. I download the latest snapshot of the linux-dvb drivers via mercurial and installed them. I took the firmware named dvb-usb-wt220u-fc03.fw. When I modprobe dvb_usb_dtt200u I get: dvb-usb: found a 'WideView WT-220U PenType Receiver (Typhoon/Freecom)' in warm state. dvb-usb: will use the device's hardware PID filter (table count: 15). DVB: registering new adapter (WideView WT-220U PenType Receiver (Typhoon/Freecom)). DVB: registering frontend 0 (WideView USB DVB-T)... input: IR-receiver inside an USB DVB receiver as /class/input/input8 dvb-usb: schedule remote query interval to 300 msecs. dvb-usb: WideView WT-220U PenType Receiver (Typhoon/Freecom) successfully initialized and connected. dvb-usb: found a 'WideView WT-220U PenType Receiver (Typhoon/Freecom)' in warm state. dvb-usb: will use the device's hardware PID filter (table count: 15). DVB: registering new adapter (WideView WT-220U PenType Receiver (Typhoon/Freecom)). DVB: registering frontend 1 (WideView USB DVB-T)... input: IR-receiver inside an USB DVB receiver as /class/input/input9 dvb-usb: schedule remote query interval to 300 msecs. dvb-usb: WideView WT-220U PenType Receiver (Typhoon/Freecom) successfully initialized and connected. usbcore: registered new driver dvb_usb_dtt200u dvb-usb: recv bulk message failed: -110 Now I am quite confused why I find two directories in /dev/dvb named adapter0 and adapter1 with adapter0: crw-rw---- 1 root video 212, 4 2. Okt 16:50 demux0 crw-rw---- 1 root video 212, 5 2. Okt 16:50 dvr0 crw-rw---- 1 root video 212, 3 2. Okt 16:50 frontend0 crw-rw---- 1 root video 212, 7 2. Okt 16:50 net0 adapter1 crw-rw---- 1 root video 212, 68 2. Okt 16:50 demux0 crw-rw---- 1 root video 212, 69 2. Okt 16:50 dvr0 crw-rw---- 1 root video 212, 67 2. Okt 16:50 frontend0 crw-rw---- 1 root video 212, 71 2. Okt 16:50 net0 I can dvbscan on both adapters with correct behaviour (but not at the same time) and vlc shows tv when using the generated channels.conf. I would like to use vdr for recording but this gives me a lot of errors (adapter1/demux0: too many open files ... and more). Can anyone tell me why I got to devices? dmesg looks to me like the firmware loads twice. Also two ir-receiver are registered and the class/input/inputX increases every time I unload and load the dvb_usb_dtt200u. Thank you very much for reading this. Bye Peter _______________________________________________ linux-dvb mailing list linux-dvb@xxxxxxxxxxx http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb
