Sorry for sending this twice, Mark... I forgot to cc the list. On 2/12/06, Mark Haun <haunma@xxxxxxxxx> wrote: > Mark Haun wrote: > > azap is showing FE_LOCK on all of my local channels. My signal numbers > > are lower than the recommended 8000 (highest is KCTS with ~ 6c00), but the > > BER is zero, so I should be seeing something, right? If I run azap with > > the "-r" option and then cat /dev/dvb/frontend0/dvr0 > test.ts there is no > > stream data (it sits there at zero size). > > Ok, so the answer was pretty obvious to anyone knowledgeable on ATSC (not > me). Trying to dump the TS to a file won't work until you've set the > video/audio PIDs in channels.conf; the make_atsc_chanconf.pl script only > fills in the other fields (station names and frequencies). To see which > PIDs are active, you can use the "dvbtraffic" utility while azap is running > on the half-finished channels.conf. > > Maybe a comment to this effect could be added to the README for [s|c|t|a]zap > in dvb-apps? > > Thanks to everyone who did the work to get these cards supported. I've been > enjoying the Olympics in 1080i on my $29 (US) Ebay special :) Works great. There is a *much* easier way.... I wrote a quick howto, one of these days I'll move it to the wiki: http://linuxtv.org/~mkrufky/atscscan Give that a try. Cheers, Mike _______________________________________________ linux-dvb@xxxxxxxxxxx http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb
