Hello there,
I would like to report that Nebula Electronics uDigiTV DVB-T USB2.0
drivers in the current stable 2.6.15.2 kernel do not work.
Syslog reports:
Linux video capture interface: v1.00
bttv: driver version 0.9.16 loaded
bttv: using 8 buffers with 2080k (520 pages) each for capture
bt878: AUDIO driver version 0.0.0 loaded
usb 4-1: new high speed USB device using ehci_hcd and address 3
dvb-usb: found a 'Nebula Electronics uDigiTV DVB-T USB2.0)' in cold
state, will try to load a firmware
dvb-usb: downloading firmware from file 'dvb-usb-digitv-01.fw' to the
'Cypress FX2'
dvb-usb: Nebula Electronics uDigiTV DVB-T USB2.0) successfully
initialized and connected.
dvb-usb: endpoint for generic control not specified.
dvb-usb: endpoint for generic control not specified.
usbcore: registered new driver dvb_usb_digitv
usb 4-1: USB disconnect, address 3
dvb-usb: generic DVB-USB module successfully deinitialized and disconnected.
usb 4-1: new high speed USB device using ehci_hcd and address 4
usb 4-1: string descriptor 0 read error: -22
usb 4-1: string descriptor 0 read error: -22
dvb-usb: found a 'Nebula Electronics uDigiTV DVB-T USB2.0)' in warm state.
dvb-usb: will pass the complete MPEG2 transport stream to the software
demuxer.
DVB: registering new adapter (Nebula Electronics uDigiTV DVB-T USB2.0)).
i2c_adapter i2c-1: SMBus Quick command not supported, can't probe for chips
dvb-usb: no frontend was attached by 'Nebula Electronics uDigiTV DVB-T
USB2.0)'
input: IR-receiver inside an USB DVB receiver as /class/input/input2
dvb-usb: schedule remote query interval to 1000 msecs.
dvb-usb: Nebula Electronics uDigiTV DVB-T USB2.0) successfully
initialized and connected.
I have also tried all 5 v4l-dvb snapshots available at
http://linuxtv.org/downloads/snapshots/ with no luck. They reported the
following in the syslog:
Linux video capture interface: v1.00
bttv: driver version 0.9.16 loaded
bttv: snapshot date 2006-01-15
bttv: using 8 buffers with 2080k (520 pages) each for capture
bt878: AUDIO driver version 0.0.0 loaded
usbcore: registered new driver dvb_usb_digitv
usb 4-1: new high speed USB device using ehci_hcd and address 3
dvb-usb: found a 'Nebula Electronics uDigiTV DVB-T USB2.0)' in cold
state, will try to load a firmware
dvb-usb: downloading firmware from file 'dvb-usb-digitv-01.fw'
dvb-usb: firmware download failed at 4956 with -22
dvb_usb_digitv: probe of 4-1:1.0 failed with error -22
I could not try the latest development version from mercurial, since
digitv.c implies that I need a new firmware file dvb-usb-digitv-02.fw,
which I haven't managed to find from anywhere.
lsusb reports the Nebula USB box as:
Bus 004 Device 004: ID 0547:0201 Anchor Chips, Inc.
The sticker at the bottom of the device doesn't say much. Mostly
"©Nebula Electronics Ltd 2005" and "Master Tuner uDigiTV USB 2.0". :)
Please let me know if I can help in solving the issue by providing any
additional information.
--
Best regards,
Tero Jänkä
_______________________________________________
linux-dvb@xxxxxxxxxxx
http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb
