Yes, you may use it for your site. Please download all files you need, as I will delete them in a few days from my server. I also added a scanned picture of the backside of the card. Florian Am Samstag, 7. Januar 2006 16:55 schrieb Gunther Mayer: > Hi, > > can I use a picture of your card and further info for inclusion to > http://www.bttv-gallery.de ? > > Also can you send me a picture of the card backside? > > Regards, Gunther > > Florian Bartels wrote: > >Hi, > > > >i made some high-res pics from the card today, you can see them under > >http://www.envisage.de/pics/DVB_card/ > >I hope this helps. Please tell me what I can do to get this card > > working... > > > >best regards, > > Florian > > > >Am Donnerstag, 5. Januar 2006 17:52 schrieb Florian Bartels: > >>Hi, > >> > >>today I bought a new DVB-S card (budget): EasyWatch PCIlight from Satelco > >>The most recent 2.6 driver from CVS does not recognize this card. > >> > >>After changing budget-av.c, the card is recognized (see output below) but > >>is not able to able to tune in with szap (see patch below). > >> > >>Following IC's are on the card (I'm not absolutely shure about the > >> numbers, as they are hard to read): > >>Philips SAA7146 > >>Philips HEC 4069UBT A1900 > >>STM STV02996 > >>Philips LCV74A > >>TI LW040A > >>Inside the receiver: > >>Philips TDA8261TWC2 C084458 TPG05232 > >> > >>I would be happy if you could tell me how I can help getting drivers > >>working. Are there any chances the drivers will work within the next 10 > >>days? I'm asking as I can only return the card within this time. > >> > >>Thanks in advance, > >> Florian > >> > >>=== lspci -v === > >>00:0e.0 Multimedia controller: Philips Semiconductors SAA7146 (rev 01) > >> Subsystem: KNC One: Unknown device 001e > >> Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- > >> ParErr- Stepping- SERR- FastB2B- > >> Status: Cap- 66MHz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- > >><TAbort- <MAbort- >SERR- <PERR- > >> Latency: 32 (3750ns min, 9500ns max) > >> Interrupt: pin A routed to IRQ 10 > >> Region 0: Memory at f6000000 (32-bit, non-prefetchable) > >> [size=512] === lspci -v === > >> > >>=== driver output after patching driver === > >>=== (note: there's also a Hauppauge Nexus installed!) === > >>Jan 5 16:49:12 shooters kernel: Linux video capture interface: v1.00 > >>Jan 5 16:49:12 shooters kernel: saa7146: register extension 'dvb'. > >>Jan 5 16:49:12 shooters kernel: ACPI: PCI Interrupt 0000:00:0c.0[A] -> > >> GSI 19 (level, low) -> IRQ 19 > >>Jan 5 16:49:12 shooters kernel: saa7146: found saa7146 @ mem f8d64000 > >>(revision 1, irq 19) (0x13c2,0x0003). > >>Jan 5 16:49:12 shooters kernel: DVB: registering new adapter > >>(Technotrend/Hauppauge WinTV Nexus-S rev2.X). > >>Jan 5 16:49:12 shooters kernel: adapter has MAC addr = 00:d0:5c:22:9f:d9 > >>Jan 5 16:49:12 shooters kernel: dvb-ttpci: gpioirq unknown type=0 len=0 > >>Jan 5 16:49:12 shooters kernel: dvb-ttpci: info @ card 0: firm f0240009, > >>rtsl b0250018, vid 71010068, app 80fb2620 > >>Jan 5 16:49:12 shooters kernel: dvb-ttpci: firmware @ card 0 supports CI > >>link layer interface > >>Jan 5 16:49:12 shooters kernel: dvb-ttpci: Crystal audio DAC @ card 0 > >>detected > >>Jan 5 16:49:12 shooters kernel: saa7146_vv: saa7146 (0): registered > >> device video0 [v4l2] > >>Jan 5 16:49:13 shooters kernel: DVB: registering frontend 0 (ST STV0299 > >>DVB-S)... > >>Jan 5 16:49:13 shooters kernel: input.c: calling hotplug without a > >> hotplug agent defined > >>Jan 5 16:49:13 shooters kernel: dvb-ttpci: found av7110-0. > >>Jan 5 16:49:13 shooters kernel: saa7146: register extension 'budget > >> dvb'. Jan 5 16:49:13 shooters kernel: saa7146: register extension > >> 'budget_ci dvb'. Jan 5 16:49:13 shooters kernel: saa7146: register > >> extension 'budget_av'. Jan 5 16:49:13 shooters kernel: ACPI: PCI > >> Interrupt 0000:00:0e.0[A] -> GSI 17 (level, low) -> IRQ 21 > >>Jan 5 16:49:13 shooters kernel: saa7146: found saa7146 @ mem f8da8000 > >>(revision 1, irq 21) (0x1894,0x001e). > >>Jan 5 16:49:13 shooters kernel: DVB: registering new adapter (KNC1 > >> DVB-S). Jan 5 16:49:13 shooters kernel: adapter failed MAC signature > >> check Jan 5 16:49:13 shooters kernel: encoded MAC from EEPROM was > >>ff:ff:ff:ff:ff:ff:ff:ff:ff:ff:ff:ff:ff:ff:ff:ff:ff:ff:ff:ff > >>Jan 5 16:49:13 shooters kernel: budget-av: ci interface initialised. > >>Jan 5 16:49:14 shooters kernel: KNC1-1: MAC addr = 00:09:d6:80:04:89 > >>Jan 5 16:49:14 shooters kernel: DVB: registering frontend 1 (ST STV0299 > >>DVB-S)... > >>Jan 5 16:49:14 shooters kernel: usbcore: registered new driver ttusb > >>Jan 5 16:49:14 shooters kernel: usbcore: registered new driver ttusb-dec > >>Jan 5 16:49:14 shooters kernel: b2c2-flexcop: B2C2 FlexcopII/II(b)/III > >>digital TV receiver chip loaded successfully > >>Jan 5 16:49:14 shooters kernel: usbcore: registered new driver > >>b2c2_flexcop_usb > >>Jan 5 16:49:14 shooters kernel: usbcore: registered new driver cinergyT2 > >>Jan 5 16:49:14 shooters kernel: usbcore: registered new driver > >>dvb_usb_vp7045 Jan 5 16:49:14 shooters kernel: usbcore: registered new > >>driver > >>dvb_usb_dtt200u > >>Jan 5 16:49:14 shooters kernel: usbcore: registered new driver > >>dvb_usb_dibusb_mb > >>Jan 5 16:49:14 shooters kernel: usbcore: registered new driver > >>dvb_usb_dibusb_mc > >>Jan 5 16:49:14 shooters kernel: usbcore: registered new driver > >>dvb_usb_a800 Jan 5 16:49:14 shooters kernel: usbcore: registered new > >>driver > >>dvb_usb_nova_t_usb2 > >>Jan 5 16:49:14 shooters kernel: usbcore: registered new driver > >>dvb_usb_umt_010 > >>Jan 5 16:49:14 shooters kernel: usbcore: registered new driver > >>dvb_usb_digitv Jan 5 16:49:14 shooters kernel: usbcore: registered new > >>driver dvb_usb_cxusb === driver output end === > >> > >>=== cvs diff === > >>retrieving revision 1.58 > >>diff -c -r1.58 budget-av.c > >>*** budget-av.c 23 Nov 2005 21:06:12 -0000 1.58 > >>--- budget-av.c 5 Jan 2006 16:36:20 -0000 > >>*************** > >>*** 913,918 **** > >>--- 913,919 ---- > >> switch (saa->pci->subsystem_device) { > >> > >> case SUBID_DVBS_KNC1: > >>+ case 0x001e: > >> if (saa->pci->subsystem_vendor == 0x1894) { > >> fe = > >>stv0299_attach(&cinergy_1200s_1894_0010_config, > >>&budget_av->budget.i2c_adap); *************** > >>*** 1177,1182 **** > >>--- 1178,1184 ---- > >> MAKE_EXTENSION_PCI(knc1s, 0x1131, 0x4f56), > >> MAKE_EXTENSION_PCI(knc1s, 0x1131, 0x0010), > >> MAKE_EXTENSION_PCI(knc1s, 0x1894, 0x0010), > >>+ MAKE_EXTENSION_PCI(knc1s, 0x1894, 0x001e), > >> MAKE_EXTENSION_PCI(knc1sp, 0x1131, 0x0011), > >> MAKE_EXTENSION_PCI(knc1c, 0x1894, 0x0020), > >> MAKE_EXTENSION_PCI(knc1cp, 0x1894, 0x0021), > >>=== cvs diff === > >> > >>_______________________________________________ > >> > >>linux-dvb@xxxxxxxxxxx > >>http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb > > > >_______________________________________________ > > > >linux-dvb@xxxxxxxxxxx > >http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb
