Hi, i made some high-res pics from the card today, you can see them under http://www.envisage.de/pics/DVB_card/ I hope this helps. Please tell me what I can do to get this card working... best regards, Florian Am Donnerstag, 5. Januar 2006 17:52 schrieb Florian Bartels: > Hi, > > today I bought a new DVB-S card (budget): EasyWatch PCIlight from Satelco > The most recent 2.6 driver from CVS does not recognize this card. > > After changing budget-av.c, the card is recognized (see output below) but > is not able to able to tune in with szap (see patch below). > > Following IC's are on the card (I'm not absolutely shure about the numbers, > as they are hard to read): > Philips SAA7146 > Philips HEC 4069UBT A1900 > STM STV02996 > Philips LCV74A > TI LW040A > Inside the receiver: > Philips TDA8261TWC2 C084458 TPG05232 > > I would be happy if you could tell me how I can help getting drivers > working. Are there any chances the drivers will work within the next 10 > days? I'm asking as I can only return the card within this time. > > Thanks in advance, > Florian > > === lspci -v === > 00:0e.0 Multimedia controller: Philips Semiconductors SAA7146 (rev 01) > Subsystem: KNC One: Unknown device 001e > Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- > Stepping- SERR- FastB2B- > Status: Cap- 66MHz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- > <TAbort- <MAbort- >SERR- <PERR- > Latency: 32 (3750ns min, 9500ns max) > Interrupt: pin A routed to IRQ 10 > Region 0: Memory at f6000000 (32-bit, non-prefetchable) [size=512] > === lspci -v === > > === driver output after patching driver === > === (note: there's also a Hauppauge Nexus installed!) === > Jan 5 16:49:12 shooters kernel: Linux video capture interface: v1.00 > Jan 5 16:49:12 shooters kernel: saa7146: register extension 'dvb'. > Jan 5 16:49:12 shooters kernel: ACPI: PCI Interrupt 0000:00:0c.0[A] -> GSI > 19 (level, low) -> IRQ 19 > Jan 5 16:49:12 shooters kernel: saa7146: found saa7146 @ mem f8d64000 > (revision 1, irq 19) (0x13c2,0x0003). > Jan 5 16:49:12 shooters kernel: DVB: registering new adapter > (Technotrend/Hauppauge WinTV Nexus-S rev2.X). > Jan 5 16:49:12 shooters kernel: adapter has MAC addr = 00:d0:5c:22:9f:d9 > Jan 5 16:49:12 shooters kernel: dvb-ttpci: gpioirq unknown type=0 len=0 > Jan 5 16:49:12 shooters kernel: dvb-ttpci: info @ card 0: firm f0240009, > rtsl b0250018, vid 71010068, app 80fb2620 > Jan 5 16:49:12 shooters kernel: dvb-ttpci: firmware @ card 0 supports CI > link layer interface > Jan 5 16:49:12 shooters kernel: dvb-ttpci: Crystal audio DAC @ card 0 > detected > Jan 5 16:49:12 shooters kernel: saa7146_vv: saa7146 (0): registered device > video0 [v4l2] > Jan 5 16:49:13 shooters kernel: DVB: registering frontend 0 (ST STV0299 > DVB-S)... > Jan 5 16:49:13 shooters kernel: input.c: calling hotplug without a hotplug > agent defined > Jan 5 16:49:13 shooters kernel: dvb-ttpci: found av7110-0. > Jan 5 16:49:13 shooters kernel: saa7146: register extension 'budget dvb'. > Jan 5 16:49:13 shooters kernel: saa7146: register extension 'budget_ci > dvb'. Jan 5 16:49:13 shooters kernel: saa7146: register extension > 'budget_av'. Jan 5 16:49:13 shooters kernel: ACPI: PCI Interrupt > 0000:00:0e.0[A] -> GSI 17 (level, low) -> IRQ 21 > Jan 5 16:49:13 shooters kernel: saa7146: found saa7146 @ mem f8da8000 > (revision 1, irq 21) (0x1894,0x001e). > Jan 5 16:49:13 shooters kernel: DVB: registering new adapter (KNC1 DVB-S). > Jan 5 16:49:13 shooters kernel: adapter failed MAC signature check > Jan 5 16:49:13 shooters kernel: encoded MAC from EEPROM was > ff:ff:ff:ff:ff:ff:ff:ff:ff:ff:ff:ff:ff:ff:ff:ff:ff:ff:ff:ff > Jan 5 16:49:13 shooters kernel: budget-av: ci interface initialised. > Jan 5 16:49:14 shooters kernel: KNC1-1: MAC addr = 00:09:d6:80:04:89 > Jan 5 16:49:14 shooters kernel: DVB: registering frontend 1 (ST STV0299 > DVB-S)... > Jan 5 16:49:14 shooters kernel: usbcore: registered new driver ttusb > Jan 5 16:49:14 shooters kernel: usbcore: registered new driver ttusb-dec > Jan 5 16:49:14 shooters kernel: b2c2-flexcop: B2C2 FlexcopII/II(b)/III > digital TV receiver chip loaded successfully > Jan 5 16:49:14 shooters kernel: usbcore: registered new driver > b2c2_flexcop_usb > Jan 5 16:49:14 shooters kernel: usbcore: registered new driver cinergyT2 > Jan 5 16:49:14 shooters kernel: usbcore: registered new driver > dvb_usb_vp7045 Jan 5 16:49:14 shooters kernel: usbcore: registered new > driver > dvb_usb_dtt200u > Jan 5 16:49:14 shooters kernel: usbcore: registered new driver > dvb_usb_dibusb_mb > Jan 5 16:49:14 shooters kernel: usbcore: registered new driver > dvb_usb_dibusb_mc > Jan 5 16:49:14 shooters kernel: usbcore: registered new driver > dvb_usb_a800 Jan 5 16:49:14 shooters kernel: usbcore: registered new > driver > dvb_usb_nova_t_usb2 > Jan 5 16:49:14 shooters kernel: usbcore: registered new driver > dvb_usb_umt_010 > Jan 5 16:49:14 shooters kernel: usbcore: registered new driver > dvb_usb_digitv Jan 5 16:49:14 shooters kernel: usbcore: registered new > driver dvb_usb_cxusb === driver output end === > > === cvs diff === > retrieving revision 1.58 > diff -c -r1.58 budget-av.c > *** budget-av.c 23 Nov 2005 21:06:12 -0000 1.58 > --- budget-av.c 5 Jan 2006 16:36:20 -0000 > *************** > *** 913,918 **** > --- 913,919 ---- > switch (saa->pci->subsystem_device) { > > case SUBID_DVBS_KNC1: > + case 0x001e: > if (saa->pci->subsystem_vendor == 0x1894) { > fe = > stv0299_attach(&cinergy_1200s_1894_0010_config, > &budget_av->budget.i2c_adap); *************** > *** 1177,1182 **** > --- 1178,1184 ---- > MAKE_EXTENSION_PCI(knc1s, 0x1131, 0x4f56), > MAKE_EXTENSION_PCI(knc1s, 0x1131, 0x0010), > MAKE_EXTENSION_PCI(knc1s, 0x1894, 0x0010), > + MAKE_EXTENSION_PCI(knc1s, 0x1894, 0x001e), > MAKE_EXTENSION_PCI(knc1sp, 0x1131, 0x0011), > MAKE_EXTENSION_PCI(knc1c, 0x1894, 0x0020), > MAKE_EXTENSION_PCI(knc1cp, 0x1894, 0x0021), > === cvs diff === > > _______________________________________________ > > linux-dvb@xxxxxxxxxxx > http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb
