Jate wrote: > I have recompiled after applying the patch. It appears to detect the > devices, but analog does not work. The messages from executing tvtime > follow. > > Linux video capture interface: v1.00 > bttv: driver version 0.9.16 loaded > bttv: using 8 buffers with 2080k (520 pages) each for capture > bttv: Bt8xx card found (0). > ACPI: PCI Interrupt Link [LNKB] enabled at IRQ 11 > PCI: setting IRQ 11 as level-triggered > ACPI: PCI Interrupt 0000:00:11.0[A] -> Link [LNKB] -> GSI 11 (level, > low) -> IRQ 11 > bttv0: Bt878 (rev 17) at 0000:00:11.0, irq: 11, latency: 64, mmio: > 0xcddfe000 > bttv0: detected: DViCO FusionHDTV 5 Lite [card=135], PCI subsystem ID > is 18ac:d500 > bttv0: using: DViCO FusionHDTV 5 Lite [card=135,autodetected] > bttv0: gpio: en=00000000, out=00000000 in=00ffffff [init] > bttv0: using tuner=64 > tuner 1-0061: chip found @ 0xc2 (bt878 #0 [sw]) > tuner 1-0061: type set to 64 (LG TDVS-H062F/TUA6034) > bttv0: registered device video0 > bttv0: registered device vbi0 > bttv0: add subdevice "dvb0" > bt878: AUDIO driver version 0.0.0 loaded > bt878: Bt878 AUDIO function found (0). > ACPI: PCI Interrupt 0000:00:11.1[A] -> Link [LNKB] -> GSI 11 (level, > low) -> IRQ 11 > bt878(0): Bt878 (rev 17) at 00:11.1, irq: 11, latency: 64, memory: > 0xcddff000 > ACPI: PCI Interrupt Link [LNKC] enabled at IRQ 3 > PCI: setting IRQ 3 as level-triggered > ACPI: PCI Interrupt 0000:00:13.2[C] -> Link [LNKC] -> GSI 3 (level, > low) -> IRQ 3 > > messages from tvtime: > bttv0: timeout: drop=43 irq=289/289, risc=039b2024, bits: HSYNC OFLOW FDSR > bttv0: reset, reinitialize > bttv0: timeout: drop=59 irq=306/306, risc=03fb001c, bits: VSYNC HSYNC > OFLOW FDSR > bttv0: reset, reinitialize > bttv0: timeout: drop=75 irq=323/323, risc=039b2024, bits: VSYNC HSYNC > OFLOW FDSR > bttv0: reset, reinitialize > > - Jate S. > What happens if you: modprobe tda9887 ? -- Michael Krufky
