[linux-dvb] Compro Videomate T200A: tuner problem?

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



Hi.

My problem seems quite similar to this one:
http://www.linuxtv.org/pipermail/linux-dvb/2005-September/004669.html

In short, I've got the latest CVS code, compiled it against the stock 
2.6.13, and loaded the saa7134-dvb module:
(My Linux flavour is Breezy Badger, by the way)

> saa7130/34: v4l2 driver version 0.2.14 loaded
> saa7130[0]: found at 0000:01:02.0, rev: 1, irq: 18, latency: 32, mmio: 
> 0xf9000000
> saa7130[0]: subsystem: 185b:c901, board: Compro Videomate DVB-T200 
> [card=71,autodetected]
> saa7130[0]: board init: gpio is 943f00
> saa7130[0]: registered input device for IR
> saa7130[0]: i2c eeprom 00: 5b 18 01 c9 54 20 1c 00 43 43 a9 1c 55 d2 
> b2 92
> saa7130[0]: i2c eeprom 10: 00 ff 86 0f ff 20 ff ff ff ff ff ff ff ff 
> ff ff
> saa7130[0]: i2c eeprom 20: 01 40 01 03 03 ff 03 01 08 ff 00 88 ff ff 
> ff ff
> saa7130[0]: i2c eeprom 30: ff ff ff ff ff ff ff ff ff ff ff ff ff ff 
> ff ff
> saa7130[0]: i2c eeprom 40: ff 02 00 c2 86 10 ff ff ff ff ff ff ff ff 
> ff ff
> saa7130[0]: i2c eeprom 50: ff ff ff ff ff ff ff ff ff ff ff ff ff ff 
> ff cb
> saa7130[0]: i2c eeprom 60: 30 ff ff ff ff ff ff ff ff ff ff ff ff ff 
> ff ff
> saa7130[0]: i2c eeprom 70: ff ff ff ff ff ff ff ff ff ff ff ff ff ff 
> ff ff
> saa7130[0]: registered device video0 [v4l2]
> saa7130[0]: registered device vbi0
> DVB: registering new adapter (saa7130[0]).
> DVB: registering frontend 0 (Philips TDA10046H DVB-T)...


If I then run tzap (with the right channels.conf file) I get this:

> tda1004x: found firmware revision 23 -- ok


and this to STDOUT:using '/dev/dvb/adapter0/frontend0' and 
'/dev/dvb/adapter0/demux0'

> tuning to 536500000 Hz
> video pid 0x0066, audio pid 0x0067
> status 00 | signal 0000 | snr ffff | ber 0001fffe | unc 00000000 |
> status 00 | signal 0000 | snr ffff | ber 0001fffe | unc 00000000 |
> status 00 | signal 0000 | snr ffff | ber 0001fffe | unc 00000000 |
> ...


I just bought a new antenna, thinking perhaps it was just bad signal, 
but there's no change at all. Am I missing a tuner in the kernel?

Thanks in advance for any tips.

Nick.


[Index of Archives]     [Linux Media]     [Video 4 Linux]     [Asterisk]     [Samba]     [Xorg]     [Xfree86]     [Linux USB]

  Powered by Linux