I have recently acquired a hauppauge nova-t card which I'm trying to get working, using current CVS + 2.6.12. dmesg output on module load: cx2388x v4l2 driver version 0.0.5 loaded ACPI: PCI Interrupt Link [LNKC] enabled at IRQ 16 ACPI: PCI Interrupt 0000:02:08.0[A] -> Link [LNKC] -> GSI 16 (level, low) -> IRQ 225 CORE cx88[0]: subsystem: 0070:9002, board: Hauppauge Nova-T DVB-T [card=18,autodetected] TV tuner 4 at 0x1fe, Radio tuner -1 at 0x1fe cx88[0]: hauppauge eeprom: model=90002, tuner=76 cx88[0]: registered IR remote control cx88[0]/0: found at 0000:02:08.0, rev: 5, irq: 225, latency: 32, mmio: 0xfb000000 cx88[0]/0: registered device video1 [v4l2] cx88[0]/0: registered device vbi1 cx2388x blackbird driver version 0.0.5 loaded cx2388x dvb driver version 0.0.5 loaded ACPI: PCI Interrupt 0000:02:08.2[A] -> Link [LNKC] -> GSI 16 (level, low) -> IRQ 225 cx88[0]/2: found at 0000:02:08.2, rev: 5, irq: 225, latency: 32, mmio: 0xfc000000 cx88[0]/2: cx2388x based dvb card DVB: registering new adapter (cx88[0]). DVB: registering frontend 1 (Conexant CX22702 DVB-T)... The card appears to tune fine with tzap, although I never get any data from it: cx88[0]/2: cx8802_timeout cx88[0]/2: cx8802_stop_dma cx88[0]/2: restarting queue cx88[0]/2: cx8802_restart_queue cx88[0]/2: cx8802_restart_queue: queue is empty cx88[0]/2: queue is empty - first active cx88[0]/2: cx8802_start_dma w: 0, h: 0, f: 2 cx88[0]/2: setting the interrupt mask cx88[0]/2: [f653cdc0/0] cx8802_buf_queue - first active is repeated over and over in the logs. I've had a bit of a poke around, but I'm at a loss as to what to try next. Thanks, Mark
