Mark Weaver wrote: > I have recently acquired a hauppauge nova-t card which I'm trying to get > working, using current CVS + 2.6.12. dmesg output on module load: > > cx2388x v4l2 driver version 0.0.5 loaded > ACPI: PCI Interrupt Link [LNKC] enabled at IRQ 16 > ACPI: PCI Interrupt 0000:02:08.0[A] -> Link [LNKC] -> GSI 16 (level, > low) -> IRQ 225 > CORE cx88[0]: subsystem: 0070:9002, board: Hauppauge Nova-T DVB-T > [card=18,autodetected] > TV tuner 4 at 0x1fe, Radio tuner -1 at 0x1fe > cx88[0]: hauppauge eeprom: model=90002, tuner=76 > cx88[0]: registered IR remote control > cx88[0]/0: found at 0000:02:08.0, rev: 5, irq: 225, latency: 32, mmio: > 0xfb000000 > cx88[0]/0: registered device video1 [v4l2] > cx88[0]/0: registered device vbi1 > cx2388x blackbird driver version 0.0.5 loaded > cx2388x dvb driver version 0.0.5 loaded > ACPI: PCI Interrupt 0000:02:08.2[A] -> Link [LNKC] -> GSI 16 (level, > low) -> IRQ 225 > cx88[0]/2: found at 0000:02:08.2, rev: 5, irq: 225, latency: 32, mmio: > 0xfc000000 > cx88[0]/2: cx2388x based dvb card > DVB: registering new adapter (cx88[0]). > DVB: registering frontend 1 (Conexant CX22702 DVB-T)... > > The card appears to tune fine with tzap, although I never get any data > from it: Are you doing tzap CHAN_XX -r ? -r is the key. > cx88[0]/2: cx8802_timeout > cx88[0]/2: cx8802_stop_dma > cx88[0]/2: restarting queue > cx88[0]/2: cx8802_restart_queue > cx88[0]/2: cx8802_restart_queue: queue is empty > cx88[0]/2: queue is empty - first active > cx88[0]/2: cx8802_start_dma w: 0, h: 0, f: 2 > cx88[0]/2: setting the interrupt mask > cx88[0]/2: [f653cdc0/0] cx8802_buf_queue - first active > > is repeated over and over in the logs. > > I've had a bit of a poke around, but I'm at a loss as to what to try next. I get the same messages with my cx88 boards. They annoy me, but I never really cared. There's probably some verbosity default setting set too high. Does anybody know if these messages are important enough to keep visible by default? -- Michael Krufky
