Hi, Nick
> After much trial and error I've managed to get the remote to work.
>
Oh excellent!
> I don't know how to create patches etc... just yet so I've included the
> mod's I've made to the saa7134-cards.c and the saa7134-input.c files to
> get this to work.
>
>
> saa7134-cards.c
> Below the switch (dev->board) { line I added the following
>
> case SAA7134_BOARD_VIDEOMATE_DVBT_300:
>
> saa7134-input.c
> Below the switch (dev->board) { line I added the following
>
> case SAA7134_BOARD_VIDEOMATE_DVBT_300:
> ir_codes = videomate_tv_pvr_codes;
> mask_keycode = 0x003F00;
> mask_keyup = 0x040000;
> break;
>
> Once I loaded the saa7134 module I was able to use evdev to see that the
> keypresses were corresponding to the correct buttons.
>
> I then grabbed the lirc.conf file from bytesex and created a lircrc file.
>
> Changed lirc to use --driver=dev/input --device=/dev/input/event1 (or what
> ever your IR points to) and then started irxevent. Ran Myth and everything
> is now working beautifully.
>
> I'm not sure if this is 100% because I basically used trial and error to
> get the result but it does work for me :)
>
Besides what Michael proposed, you might also send me the files you
modified and i will check them in.
Thanks a lot
Hartmut
