Hi Is it possible that I have those problems **************** **************** (when I load the bttv module # modprobe bttv my system don't see the pinnacle sat as a dvb-s card as you can see it doesn't create dvb device bttv: driver version 0.9.15 loaded bttv: using 8 buffers with 2080k (520 pages) each for capture bttv: Bt8xx card found (0). ACPI: PCI interrupt 0000:02:07.0[A] -> GSI 19 (level, low) -> IRQ 177 bttv0: Bt878 (rev 17) at 0000:02:07.0, irq: 177, latency: 64, mmio: 0xf7c00000 bttv0: detected: Pinnacle PCTV Sat [card=94], PCI subsystem ID is 11bd:001c bttv0: using: Pinnacle PCTV Sat [card=94,autodetected] bttv0: gpio: en=00000000, out=00000000 in=001f00fc [init] i2c-algo-bit.o: (0) scl=1, sda=1 i2c-algo-bit.o: (1) scl=1, sda=0 i2c-algo-bit.o: (2) scl=1, sda=1 i2c-algo-bit.o: (3) scl=0, sda=1 i2c-algo-bit.o: (4) scl=1, sda=1 i2c-algo-bit.o: bt878 #0 [sw] passed test. bttv0: using tuner=-1 bttv0: registered device video0 bttv0: registered device vbi0 bttv0: PLL: 28636363 => 35468950 . ok ) ***************** ***************** with my dvb-s pinnacle card because on my system there is also another pci tv card (typhoon pci tv tuner chipset philips saa7134)? Perhaps my pinnacle sat card conflicts with typhoon pci tv tuner. Is it possiblie? I use my card if I load the saa7134 module # modprobe saa7134 card=2 tuner=11 Do anyone have two tv cards on the same computer? are they working correctly? Can I use both the pctv cards? Do I have to remove the saa7134 card from the pci slot if I want to use the pinnacle sat card? Or it's only necessary not load the module (saa7134) for the typhoon card ? Or these two cards cannot conflict because the chipsets and modules are different? what do you think? thank for all suggestion Nando ___________________________________ Yahoo! Mail: gratis 1GB per i messaggi e allegati da 10MB http://mail.yahoo.it
