HI I have re-compile drivers and modules http://www.linuxtv.org/downloads/linuxtv-dvb-1.1.1.tar.bz2 and bttv (bt878) http://bytesex.org/bttv/ I excute with root's privileges modprobe bttv i2c_hw=1 card=0x68 modprobe dvb-bt8xx modprobe cx24110 and dmesg show me bttv: driver version 0.9.15 loaded bttv: using 8 buffers with 2080k (520 pages) each for capture bttv: Bt8xx card found (0). ACPI: PCI interrupt 0000:02:07.0[A] -> GSI 19 (level, low) -> IRQ 177 bttv0: Bt878 (rev 17) at 0000:02:07.0, irq: 177, latency: 64, mmio: 0xf7c00000 bttv0: detected: Pinnacle PCTV Sat [card=94], PCI subsystem ID is 11bd:001c bttv0: using: Nebula Electronics DigiTV [card=104,insmod option] bttv0: gpio: en=00000000, out=00000000 in=009f00fc [init] bttv0: using tuner=-1 bttv0: registered device video0 bttv0: registered device vbi0 bttv0: PLL: 28636363 => 35468950 . ok bttv0: add subdevice "dvb0" bt878: AUDIO driver version 0.0.0 loaded bt878: Bt878 AUDIO function found (0). ACPI: PCI interrupt 0000:02:07.1[A] -> GSI 19 (level, low) -> IRQ 177 bt878(0): Bt878 (rev 17) at 02:07.1, irq: 177, latency: 64, memory: 0xf7d00000 dvb_bt8xx: Unknown parameter `debug:Turn' DVB: registering new adapter (bttv0). xxx attach DVB: registering frontend 0 (Conexant CX24110 with CX24108 tuner, aka HM1221/HM1811)... I think that now it has to work right? even if I declare that my dvb-s pinnacle card is a Nebula (I think that Nebula is similar to Pinnacle) in the output of dmesg I read that the system has created a subdevice dvb and it has associated a frontend connexant Therefore so I can proceed without fears that my system is going down (the card is caught fire) with the scan of the transponder to obtain the channel list with szap http://www.linuxtv.org/downloads/linuxtv-dvb-apps-1.1.0.tar.bz2 Can I ask you your opinion about the output of dmesg ? Do you have any suggestion? Thanks a lots (thank nico) ___________________________________ Yahoo! Mail: gratis 1GB per i messaggi e allegati da 10MB http://mail.yahoo.it
