Am Sonntag, 31. Juli 2005 01:18 schrieben Sie: > Thats right -- but its already supposedly being done in the driver :( > > Hmm, I reckon the CI code is mixing up the non-CI cards.. I was having a > problem like this with my KNC-1-S (nonplus) with CI module. > > According to the budget-av.c, the GPIOs for CI are connected as follows: > * 0 - Vcc/Reset (Reset is controlled by capacitor) > * 1 - Attribute Memory > * 2 - Card Enable (Active Low) > * 3 - Card Detect > > However, I also found that GPIO2 controls the frontend on my DVBT card as > well as the CI module card enable :( > > Try adding in: > saa7146_setgpio(saa, 2, SAA7146_GPIO_OUTLO); > > in budget-av.c/frontend_init() in the bit where it does > "Enable / PowerON Frontend" > > and see if that helps. > > Can you explain what the card does - i.e. in "video" mode, can you see a > DVB signal at all - or is it only video in from the analogue connector on > the card? I seem to remember it was either-or, but I can't remember which > GPIO does the switching. I tried the additional GPIO2 control, but it didn't help - I still get the message, that no frontend was found. I am not sure if the card does either video or dvb mode - For video input it has an S-VHS connector. The i2cdetect data hasn't changed with the GPIO2 control, too. I wasn't able to spot an stv0299b-chipset on the card, but this may be, because of the closed tuner-box, so I can't look into it. -Julian
