> Kenneth Aafl?y schrieb: > >> On Thursday 10 March 2005 05:10, Oliver Endriss wrote: >> >>> It's just a new card revision. >>> >>> According to >>> http://vdrportal.de/board/thread.php?postid=276932#post276932 >>> there is a BSBE1-502A tuner on the card. This tuner is stv0299-based, >>> see http://www.linuxtv.org/pipermail/linux-dvb/2005-March/000386.html >> >> >> >> Ok, sounds good. >> >> >>> First of all you should check whether 13V/18V voltage switching and >>> 22kHz signal generation work. If not you have to find out how the LNBP20 >>> is wired to the GPIOs. >>> >>> Imho it should not be too difficult to make the driver work if you own >>> such a card. :-( >> >> >> >> Hubert, would you mind trying cvs with the attached patch then? > > > Kenneth, > > thank you for the patch. I just updatet the cvs and ran then patch. As an additional test I have used the patch with the suse default dvb sources (dvb-1.1.0_CVS20040812-7). Quite the same results except: dvbscan waits much longer (about 1 minute) until it writes the error message. And kaxtv shows after a little bit thinking 100 % signal and 100 % SNR in nice colors. But thats all, nothing else is found: ----- Using DVB card "STV0299/TSA5059/SL1935 based" tuning DVB-S to 12551000 v 22000000 inv:2 fecH:5 polling.... Getting frontend event polling.... Getting frontend event polling.... polling.... polling.... ------ Where is the problem (the cabeling is ok, windows works)? Did I miss something?
