Sid, Reverting to 2.6.10-3 patch build caused everything to burst into life again. The Myth pids thing was a red herring. Newer builds of myth no longer use the pid table, I just had not noticed. So it looks like that at some point the snapshots stopped working with the Conexant based Nova-T card. Roger (G4TOT but not very active) > -----Original Message----- > From: linux-dvb-bounces@xxxxxxxxxxx [mailto:linux-dvb-bounces@xxxxxxxxxxx] > On Behalf Of Sid Boyce > Sent: 03 March 2005 03:16 > To: linux-dvb@xxxxxxxxxxx > Subject: Re: [linux-dvb] Problem with scanning using latest cx88 build > (Nova-T) > > Roger James wrote: > > I have just updated to the latest cx88 driver (video4linux-20050302) and > > it has broken my Myth setup. Myth has deleted all its PIDs from the > > database (I guess that is a myth problem). > > > > > > > > I cannot seem to get any rescans to work to get the PIDs back again. The > > myth rescan just hangs (interruptibly) and never completes. > > > > If I use tzap to tune to a channel that works fine and I get lock, but > > If I then run scan then I get the a "filter timeout" on PIDS 0 and > 11. > > > > > > > > Anyone got any ideas. What has changed from the builds of about 1 month > > ago. It was all working then. (I really must learn to leave well alone L > ). > > > > > > > > Am I missing some extra driver config now. > > > > > > > > Roger > > > > > > ------------------------------------------------------------------------ > > > > _______________________________________________ > > > > linux-dvb@xxxxxxxxxxx > > http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb > > With 2.6.11 and the same snapshot with kaffeine-dvb, I can't get a > display or audio. The snapshot builds. The only difference from the > working 2.6.10 + video4linux-20050120 is the or51132 module which seems > to require firmware - not needed with this card. From dmesg --- > bttv: driver version 0.9.15 loaded > bttv: snapshot date 2005-03-02 > bttv: using 8 buffers with 2080k (520 pages) each for capture > kobject_register failed for v4l1_compat (-17) > [<c020a421>] kobject_register+0x51/0x60 > [<c0135b47>] mod_sysfs_setup+0x57/0xb0 > [<c0136de1>] load_module+0x971/0xa60 > [<c0136f16>] sys_init_module+0x46/0x1e0 > [<c0150f08>] sys_munmap+0x48/0x70 > [<c010305d>] sysenter_past_esp+0x52/0x75 > cx8800: Unknown parameter `radio' > cx2388x dvb driver version 0.0.4 loaded > cx2388x: snapshot date 2005-03-02 > cx88[0]: subsystem: 0070:9002, board: Hauppauge Nova-T DVB-T > [card=18,autodetected] > cx88[0]: hauppauge eeprom: model=90002, tuner=76 > cx88[0]: registered IR remote control > ACPI: PCI Interrupt Link [APC3] enabled at IRQ 18 > ACPI: PCI interrupt 0000:01:08.2[A] -> GSI 18 (level, high) -> IRQ 18 > cx88[0]/2: found at 0000:01:08.2, rev: 5, irq: 18, latency: 32, mmio: > 0xe5000000 > cx88[0]/2: cx2388x based dvb card > DVB: registering new adapter (cx88[0]). > DVB: registering frontend 0 (Hauppauge Nova-T DVB-T)... > > Modules loaded. > --------------- > evdev 9152 0 > cx88_dvb 7300 0 > cx8802 9220 1 cx88_dvb > mt352 7940 1 cx88_dvb > or51132 10692 1 cx88_dvb > video_buf_dvb 6276 1 cx88_dvb > dvb_core 77224 1 video_buf_dvb > cx22702 9732 1 cx88_dvb > dvb_pll 5188 3 cx88_dvb,or51132,cx22702 > cx88xx 48032 2 cx88_dvb,cx8802 > ir_common 7940 1 cx88xx > bttv 146320 0 > video_buf 18692 5 cx88_dvb,cx8802,video_buf_dvb,cx88xx,bttv > v4l2_common 6528 0 > btcx_risc 5768 3 cx8802,cx88xx,bttv > tveeprom 13272 2 cx88xx,bttv > nvidia 3465724 12 > video 15364 0 > > I've a hunch the snapshots don't work with this card. I'll next try it > with 2.6.11 and the 20050120 snapshot. > Regards > Sid. > -- > Sid Boyce .... Hamradio G3VBV and Keen Flyer > =====ALMOST ALL LINUX USED HERE, Solaris 10 SPARC is just for play===== > > _______________________________________________ > > linux-dvb@xxxxxxxxxxx > http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb
