Roger James wrote: > I have just updated to the latest cx88 driver (video4linux-20050302) and > it has broken my Myth setup. Myth has deleted all its PIDs from the > database (I guess that is a myth problem). > > > > I cannot seem to get any rescans to work to get the PIDs back again. The > myth rescan just hangs (interruptibly) and never completes. > > If I use tzap to tune to a channel that works fine and I get lock, but > If I then run scan then I get the a ?filter timeout? on PIDS 0 and 11. > > > > Anyone got any ideas. What has changed from the builds of about 1 month > ago. It was all working then. (I really must learn to leave well alone L ). > > > > Am I missing some extra driver config now. > > > > Roger > > > ------------------------------------------------------------------------ > > _______________________________________________ > > linux-dvb@xxxxxxxxxxx > http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb With 2.6.11 and the same snapshot with kaffeine-dvb, I can't get a display or audio. The snapshot builds. The only difference from the working 2.6.10 + video4linux-20050120 is the or51132 module which seems to require firmware - not needed with this card. From dmesg --- bttv: driver version 0.9.15 loaded bttv: snapshot date 2005-03-02 bttv: using 8 buffers with 2080k (520 pages) each for capture kobject_register failed for v4l1_compat (-17) [<c020a421>] kobject_register+0x51/0x60 [<c0135b47>] mod_sysfs_setup+0x57/0xb0 [<c0136de1>] load_module+0x971/0xa60 [<c0136f16>] sys_init_module+0x46/0x1e0 [<c0150f08>] sys_munmap+0x48/0x70 [<c010305d>] sysenter_past_esp+0x52/0x75 cx8800: Unknown parameter `radio' cx2388x dvb driver version 0.0.4 loaded cx2388x: snapshot date 2005-03-02 cx88[0]: subsystem: 0070:9002, board: Hauppauge Nova-T DVB-T [card=18,autodetected] cx88[0]: hauppauge eeprom: model=90002, tuner=76 cx88[0]: registered IR remote control ACPI: PCI Interrupt Link [APC3] enabled at IRQ 18 ACPI: PCI interrupt 0000:01:08.2[A] -> GSI 18 (level, high) -> IRQ 18 cx88[0]/2: found at 0000:01:08.2, rev: 5, irq: 18, latency: 32, mmio: 0xe5000000 cx88[0]/2: cx2388x based dvb card DVB: registering new adapter (cx88[0]). DVB: registering frontend 0 (Hauppauge Nova-T DVB-T)... Modules loaded. --------------- evdev 9152 0 cx88_dvb 7300 0 cx8802 9220 1 cx88_dvb mt352 7940 1 cx88_dvb or51132 10692 1 cx88_dvb video_buf_dvb 6276 1 cx88_dvb dvb_core 77224 1 video_buf_dvb cx22702 9732 1 cx88_dvb dvb_pll 5188 3 cx88_dvb,or51132,cx22702 cx88xx 48032 2 cx88_dvb,cx8802 ir_common 7940 1 cx88xx bttv 146320 0 video_buf 18692 5 cx88_dvb,cx8802,video_buf_dvb,cx88xx,bttv v4l2_common 6528 0 btcx_risc 5768 3 cx8802,cx88xx,bttv tveeprom 13272 2 cx88xx,bttv nvidia 3465724 12 video 15364 0 I've a hunch the snapshots don't work with this card. I'll next try it with 2.6.11 and the 20050120 snapshot. Regards Sid. -- Sid Boyce .... Hamradio G3VBV and Keen Flyer =====ALMOST ALL LINUX USED HERE, Solaris 10 SPARC is just for play=====
