That should clean up. Thank you. Reviewed-by: Insop Song <insop.song@xxxxxxxxxxxxx> ISS On Fri, Oct 03, 2014 at 10:37:46AM -0700, Joe Perches wrote: > On Fri, 2014-10-03 at 10:18 -0700, Joe Perches wrote: > > On Sat, 2014-10-04 at 01:59 +0900, Masanari Iida wrote: > > > This patch remove unnecessary KERN_INFO in pr_info() > > [] > > > diff --git a/drivers/staging/gs_fpgaboot/gs_fpgaboot.c b/drivers/staging/gs_fpgaboot/gs_fpgaboot.c > > [] > > > @@ -58,7 +58,7 @@ static void datadump(char *msg, void *m, int n) > > > > > > for (i = 0; i < n; i++) { > > > if ((i&0xf) == 0) > > > - pr_info(KERN_INFO "\n 0x%4x: ", i); > > > + pr_info("\n 0x%4x: ", i); > > > > > > pr_info("%02X ", c[i]); > > > } > > > > OK, but this block should use print_hex_dump instead. > > Maybe: > --- > drivers/staging/gs_fpgaboot/gs_fpgaboot.c | 25 ++----------------------- > 1 file changed, 2 insertions(+), 23 deletions(-) > > diff --git a/drivers/staging/gs_fpgaboot/gs_fpgaboot.c b/drivers/staging/gs_fpgaboot/gs_fpgaboot.c > index 6aa9d7c..9764a9a 100644 > --- a/drivers/staging/gs_fpgaboot/gs_fpgaboot.c > +++ b/drivers/staging/gs_fpgaboot/gs_fpgaboot.c > @@ -46,27 +46,6 @@ static char *file = "xlinx_fpga_firmware.bit"; > module_param(file, charp, S_IRUGO); > MODULE_PARM_DESC(file, "Xilinx FPGA firmware file."); > > -#ifdef DEBUG_FPGA > -static void datadump(char *msg, void *m, int n) > -{ > - int i; > - unsigned char *c; > - > - pr_info("=== %s ===\n", msg); > - > - c = m; > - > - for (i = 0; i < n; i++) { > - if ((i&0xf) == 0) > - pr_info(KERN_INFO "\n 0x%4x: ", i); > - > - pr_info("%02X ", c[i]); > - } > - > - pr_info("\n"); > -} > -#endif /* DEBUG_FPGA */ > - > static void read_bitstream(char *bitdata, char *buf, int *offset, int rdsize) > { > memcpy(buf, bitdata + *offset, rdsize); > @@ -220,9 +199,9 @@ static int gs_download_image(struct fpgaimage *fimage, enum wbus bus_bytes) > size = fimage->lendata; > > #ifdef DEBUG_FPGA > - datadump("bitfile sample", bitdata, 0x100); > + print_hex_dump_bytes("bitfile sample: ", DUMP_PREFIX_OFFSET, > + bitdata, 0x100); > #endif /* DEBUG_FPGA */ > - > if (!xl_supported_prog_bus_width(bus_bytes)) { > pr_err("unsupported program bus width %d\n", > bus_bytes); > > _______________________________________________ devel mailing list devel@xxxxxxxxxxxxxxxxxxxxxx http://driverdev.linuxdriverproject.org/mailman/listinfo/driverdev-devel