Re: [PATCH] staging:gs_fpgaboot: Remove KERN_INFO in pr_info()

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On Fri, 2014-10-03 at 10:18 -0700, Joe Perches wrote:
> On Sat, 2014-10-04 at 01:59 +0900, Masanari Iida wrote:
> > This patch remove unnecessary KERN_INFO in pr_info()
> []
> > diff --git a/drivers/staging/gs_fpgaboot/gs_fpgaboot.c b/drivers/staging/gs_fpgaboot/gs_fpgaboot.c
> []
> > @@ -58,7 +58,7 @@ static void datadump(char *msg, void *m, int n)
> >  
> >  	for (i = 0; i < n; i++) {
> >  		if ((i&0xf) == 0)
> > -			pr_info(KERN_INFO "\n  0x%4x: ", i);
> > +			pr_info("\n  0x%4x: ", i);
> >  
> >  		pr_info("%02X ", c[i]);
> >  	}
> 
> OK, but this block should use print_hex_dump instead.

Maybe:
---
 drivers/staging/gs_fpgaboot/gs_fpgaboot.c | 25 ++-----------------------
 1 file changed, 2 insertions(+), 23 deletions(-)

diff --git a/drivers/staging/gs_fpgaboot/gs_fpgaboot.c b/drivers/staging/gs_fpgaboot/gs_fpgaboot.c
index 6aa9d7c..9764a9a 100644
--- a/drivers/staging/gs_fpgaboot/gs_fpgaboot.c
+++ b/drivers/staging/gs_fpgaboot/gs_fpgaboot.c
@@ -46,27 +46,6 @@ static char	*file = "xlinx_fpga_firmware.bit";
 module_param(file, charp, S_IRUGO);
 MODULE_PARM_DESC(file, "Xilinx FPGA firmware file.");
 
-#ifdef DEBUG_FPGA
-static void datadump(char *msg, void *m, int n)
-{
-	int i;
-	unsigned char *c;
-
-	pr_info("=== %s ===\n", msg);
-
-	c = m;
-
-	for (i = 0; i < n; i++) {
-		if ((i&0xf) == 0)
-			pr_info(KERN_INFO "\n  0x%4x: ", i);
-
-		pr_info("%02X ", c[i]);
-	}
-
-	pr_info("\n");
-}
-#endif /* DEBUG_FPGA */
-
 static void read_bitstream(char *bitdata, char *buf, int *offset, int rdsize)
 {
 	memcpy(buf, bitdata + *offset, rdsize);
@@ -220,9 +199,9 @@ static int gs_download_image(struct fpgaimage *fimage, enum wbus bus_bytes)
 	size = fimage->lendata;
 
 #ifdef DEBUG_FPGA
-	datadump("bitfile sample", bitdata, 0x100);
+	print_hex_dump_bytes("bitfile sample: ", DUMP_PREFIX_OFFSET,
+			     bitdata, 0x100);
 #endif /* DEBUG_FPGA */
-
 	if (!xl_supported_prog_bus_width(bus_bytes)) {
 		pr_err("unsupported program bus width %d\n",
 				bus_bytes);


_______________________________________________
devel mailing list
devel@xxxxxxxxxxxxxxxxxxxxxx
http://driverdev.linuxdriverproject.org/mailman/listinfo/driverdev-devel




[Index of Archives]     [Linux Driver Backports]     [DMA Engine]     [Linux GPIO]     [Linux SPI]     [Video for Linux]     [Linux USB Devel]     [Linux Coverity]     [Linux Audio Users]     [Linux Kernel]     [Linux SCSI]     [Yosemite Backpacking]
  Powered by Linux