Some parts of the documentation may lead the reader to think that the
socket's own frames are always received when CAN_RAW_RECV_OWN_MSGS is
enabled, but all frames are subject to filtering.
As explained by Marc Kleine-Budde:
On TX complete of a CAN frame it's pushed into the RX path of the
networking stack, along with the information of the originating socket.
Then the CAN frame is delivered into AF_CAN, where it is passed on to
all registered receivers depending on filters. One receiver is the
sending socket in CAN_RAW. Then in CAN_RAW the it is checked if the
sending socket has RECV_OWN_MSGS enabled.
Signed-off-by: Erik Flodin <erik@xxxxxxxxx>
---
Documentation/networking/can.rst | 2 ++
1 file changed, 2 insertions(+)
diff --git a/Documentation/networking/can.rst b/Documentation/networking/can.rst
index f8dae662e454..f34cb0e4460e 100644
--- a/Documentation/networking/can.rst
+++ b/Documentation/networking/can.rst
@@ -608,6 +608,8 @@ demand:
setsockopt(s, SOL_CAN_RAW, CAN_RAW_RECV_OWN_MSGS,
&recv_own_msgs, sizeof(recv_own_msgs));
+Note that reception of a socket's own CAN frames are subject to the same
+filtering as other CAN frames (see :ref:`socketcan-rawfilter`).
.. _socketcan-rawfd:
--
2.31.0
