Hi Joerg, >>> RESEND because of missing the correct Ccs. Original patch is [0]. >>> >>> This patch adds the device ID for the bluetooth chip used in the >>> AMPAK AP6212 WiFi+Bluetooth module. The AP6212 is used on several >>> BananaPi boards, e.g. M2-Ultra. >>> >>> The AP6212 is a combo module, where the WiFi chip is identified as >>> BCM43430A0 whereas the Bluetooth chip identifies itself as 4343A0. Note, >>> the missing '0' before the 'A0'. >>> >>> The AP6212 needs a firmware blob. Loading the provided firmware file >>> from the BananaPi vendor, the adapter name is printed as >>> 'BCM4343A0 26MHz AP6212_CL1-0061': >>> >>> ''' >>> hci0: Type: Primary Bus: UART >>> BD Address: 43:43:A0:12:1F:AC ACL MTU: 1021:8 SCO MTU: 64:1 >>> UP RUNNING >>> RX bytes:3076 acl:0 sco:0 events:278 errors:0 >>> TX bytes:39726 acl:0 sco:0 commands:279 errors:0 >>> Features: 0xbf 0xfe 0xcf 0xfe 0xdb 0xff 0x7b 0x87 >>> Packet type: DM1 DM3 DM5 DH1 DH3 DH5 HV1 HV2 HV3 >>> Link policy: RSWITCH SNIFF >>> Link mode: SLAVE ACCEPT >>> Name: 'BCM4343A0 26MHz AP6212_CL1-0061' >>> Class: 0x000000 >>> Service Classes: Unspecified >>> Device Class: Miscellaneous, >>> HCI Version: 4.1 (0x7) Revision: 0xf2 >>> LMP Version: 4.1 (0x7) Subversion: 0x2122 >>> Manufacturer: Broadcom Corporation (15) >>> ''' >>> >>> [0] https://www.spinics.net/lists/linux-bluetooth/msg71876.html >>> >>> Signed-off-by: Jörg Krause <joerg.krause@embedded.rocks> >>> --- >>> drivers/bluetooth/btbcm.c | 1 + >>> 1 file changed, 1 insertion(+) >> >> can you use git-send-email so that I get a patch that is not base64 encoded. Otherwise I can not apply it. > > I did use git-send-email, but you're right, I set the transferencoding > to base64. Shall I use 8bit instead? I need the patch portion in plain ASCII if possible. Or something that git-am accepts. Regards Marcel -- To unsubscribe from this list: send the line "unsubscribe linux-bluetooth" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
