Hi Marcel, On Thu, 2018-01-18 at 08:45 +0100, Marcel Holtmann wrote: > Hi Joerg, > > > RESEND because of missing the correct Ccs. Original patch is [0]. > > > > This patch adds the device ID for the bluetooth chip used in the > > AMPAK AP6212 WiFi+Bluetooth module. The AP6212 is used on several > > BananaPi boards, e.g. M2-Ultra. > > > > The AP6212 is a combo module, where the WiFi chip is identified as > > BCM43430A0 whereas the Bluetooth chip identifies itself as 4343A0. Note, > > the missing '0' before the 'A0'. > > > > The AP6212 needs a firmware blob. Loading the provided firmware file > > from the BananaPi vendor, the adapter name is printed as > > 'BCM4343A0 26MHz AP6212_CL1-0061': > > > > ''' > > hci0: Type: Primary Bus: UART > > BD Address: 43:43:A0:12:1F:AC ACL MTU: 1021:8 SCO MTU: 64:1 > > UP RUNNING > > RX bytes:3076 acl:0 sco:0 events:278 errors:0 > > TX bytes:39726 acl:0 sco:0 commands:279 errors:0 > > Features: 0xbf 0xfe 0xcf 0xfe 0xdb 0xff 0x7b 0x87 > > Packet type: DM1 DM3 DM5 DH1 DH3 DH5 HV1 HV2 HV3 > > Link policy: RSWITCH SNIFF > > Link mode: SLAVE ACCEPT > > Name: 'BCM4343A0 26MHz AP6212_CL1-0061' > > Class: 0x000000 > > Service Classes: Unspecified > > Device Class: Miscellaneous, > > HCI Version: 4.1 (0x7) Revision: 0xf2 > > LMP Version: 4.1 (0x7) Subversion: 0x2122 > > Manufacturer: Broadcom Corporation (15) > > ''' > > > > [0] https://www.spinics.net/lists/linux-bluetooth/msg71876.html > > > > Signed-off-by: Jörg Krause <joerg.krause@embedded.rocks> > > --- > > drivers/bluetooth/btbcm.c | 1 + > > 1 file changed, 1 insertion(+) > > can you use git-send-email so that I get a patch that is not base64 encoded. Otherwise I can not apply it. I did use git-send-email, but you're right, I set the transferencoding to base64. Shall I use 8bit instead? Best regards, Jörg Krause -- To unsubscribe from this list: send the line "unsubscribe linux-bluetooth" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
