On Sunday 03 May 2009 23:05:07 Bill Allen wrote: > I have set two footswitches to send CC-26 1 > and CC-26 0 respectively. Then in jack-rack I bind the Enable button to > MIDI Controller 26 Min Value 0, Max Value 1. The good news is that when I > hit the CC 26 0 switch, if the enable switch for the filter is active, it > goes off. Half the battle won. But, I can't get the filter enable to go > on with anything I've tried. Using PD I've verified that the pedal is > sending the CC 26 1, but still no joy. > > Any clues or helpful hints? The on/off controls in jack-rack can be enabled by sending a controller value of 127. All values other than 0 and 127 do nothing. By the way, you may be interested in the UnO firmware for the FCB1010: http://www.ossandust.be/ One of the many improvements over the official Behringer firmware is a stompbox mode, which would allow you to use a single button on the FCB1010 to toggle the effect, with the button's LED showing whether the effect is on or off. Dominic _______________________________________________ Linux-audio-user mailing list Linux-audio-user@xxxxxxxxxxxxxxxxxxxx http://lists.linuxaudio.org/mailman/listinfo/linux-audio-user
