Hi, * Tim <termtech@xxxxxxxxxx> [2017-08-10 20:51]: [...] > So, are you saying that ShowQ actually runs, then shows > the error message some time later after usage, or > right away upon starting it shows that message box? It shows the message box right away at startup, then, upon confirming that message box, showq exits. > Here I am able to run ShowQ and I created a wave-file cue and > was able to preview (listen to) it no problem. Thank you, I never got so far. > I also created a midi patch in the patch section, and > it connected to my midi ports no problem. > > I can tell by the listed port names that it uses > ALSA for midi, not Jack midi. > > Some quirks though: The wave preview worked fine the first time, > but upon restarting ShowQ and doing the same steps, it would > not start playing until I pressed a few other things, not sure what, > but I think I pressed menu Cue -> Load, then it worked. > Also the midi ports don't show up in the list until > an actual left-hand list item is clicked and enabled. > > But still no exit. cheers, P _______________________________________________ Linux-audio-user mailing list Linux-audio-user@xxxxxxxxxxxxxxxxxxxx https://lists.linuxaudio.org/listinfo/linux-audio-user
