+ Kalle Valo for +1T
On 2021-02-05 21:07, Venkata Lakshmi Narayana Gubba wrote:
If BT SoC is running with ROM FW then just return in
qca_suspend function as ROM FW does not support
in-band sleep.
Fixes: 2be43abac5a8 ("Bluetooth: hci_qca: Wait for timeout during
suspend")
Signed-off-by: Venkata Lakshmi Narayana Gubba <gubbaven@xxxxxxxxxxxxxx>
---
drivers/bluetooth/hci_qca.c | 12 +++++++++++-
1 file changed, 11 insertions(+), 1 deletion(-)
diff --git a/drivers/bluetooth/hci_qca.c b/drivers/bluetooth/hci_qca.c
index ff2fb68..de36af6 100644
--- a/drivers/bluetooth/hci_qca.c
+++ b/drivers/bluetooth/hci_qca.c
@@ -77,7 +77,8 @@ enum qca_flags {
QCA_MEMDUMP_COLLECTION,
QCA_HW_ERROR_EVENT,
QCA_SSR_TRIGGERED,
- QCA_BT_OFF
+ QCA_BT_OFF,
+ QCA_ROM_FW
};
enum qca_capabilities {
@@ -1664,6 +1665,7 @@ static int qca_setup(struct hci_uart *hu)
if (ret)
return ret;
+ clear_bit(QCA_ROM_FW, &qca->flags);
/* Patch downloading has to be done without IBS mode */
set_bit(QCA_IBS_DISABLED, &qca->flags);
@@ -1721,12 +1723,14 @@ static int qca_setup(struct hci_uart *hu)
hu->hdev->cmd_timeout = qca_cmd_timeout;
} else if (ret == -ENOENT) {
/* No patch/nvm-config found, run with original fw/config */
+ set_bit(QCA_ROM_FW, &qca->flags);
ret = 0;
} else if (ret == -EAGAIN) {
/*
* Userspace firmware loader will return -EAGAIN in case no
* patch/nvm-config is found, so run with original fw/config.
*/
+ set_bit(QCA_ROM_FW, &qca->flags);
ret = 0;
}
@@ -2103,6 +2107,12 @@ static int __maybe_unused qca_suspend(struct
device *dev)
set_bit(QCA_SUSPENDING, &qca->flags);
+ /* if BT SoC is running with default firmware then it does not
+ * support in-band sleep
+ */
+ if (test_bit(QCA_ROM_FW, &qca->flags))
+ return 0;
+
/* During SSR after memory dump collection, controller will be
* powered off and then powered on.If controller is powered off
* during SSR then we should wait until SSR is completed.
