[PATCH] scsi: ufs: create a hook for unipro dme control

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



Based on ufshci spec, it defines that "Offset C0h to FFh" belong
to vendor specific. If cpu vendor doesn't support these commands, it
makes the dme errors:

ufs: dme-set: attr-id 0xd041 val 0x1fff failed 0 retries
ufs: dme-set: attr-id 0xd042 val 0xffff failed 0 retries
ufs: dme-set: attr-id 0xd043 val 0x7fff failed 0 retries

Create a hook for unipro vendor-specific commands.

Signed-off-by: Leo Liou <leoliou@xxxxxxxxxx>
---
 drivers/scsi/ufs/ufs-qcom.c | 11 +++++++++++
 drivers/scsi/ufs/ufs-qcom.h |  5 +++++
 drivers/scsi/ufs/ufshcd.c   |  7 +------
 drivers/scsi/ufs/ufshcd.h   |  8 ++++++++
 drivers/scsi/ufs/unipro.h   |  4 ----
 5 files changed, 25 insertions(+), 10 deletions(-)

diff --git a/drivers/scsi/ufs/ufs-qcom.c b/drivers/scsi/ufs/ufs-qcom.c
index 2206b1e4b774..f2a925587029 100644
--- a/drivers/scsi/ufs/ufs-qcom.c
+++ b/drivers/scsi/ufs/ufs-qcom.c
@@ -759,6 +759,16 @@ static int ufs_qcom_pwr_change_notify(struct ufs_hba *hba,
 	return ret;
 }
 
+static void ufs_qcom_unipro_dme_set(struct ufs_hba *hba)
+{
+	ufshcd_dme_set(hba, UIC_ARG_MIB(DME_LocalFC0ProtectionTimeOutVal),
+		       DL_FC0ProtectionTimeOutVal_Default);
+	ufshcd_dme_set(hba, UIC_ARG_MIB(DME_LocalTC0ReplayTimeOutVal),
+		       DL_TC0ReplayTimeOutVal_Default);
+	ufshcd_dme_set(hba, UIC_ARG_MIB(DME_LocalAFC0ReqTimeOutVal),
+		       DL_AFC0ReqTimeOutVal_Default);
+}
+
 static int ufs_qcom_quirk_host_pa_saveconfigtime(struct ufs_hba *hba)
 {
 	int err;
@@ -1469,6 +1479,7 @@ static const struct ufs_hba_variant_ops ufs_hba_qcom_vops = {
 	.hce_enable_notify      = ufs_qcom_hce_enable_notify,
 	.link_startup_notify    = ufs_qcom_link_startup_notify,
 	.pwr_change_notify	= ufs_qcom_pwr_change_notify,
+	.unipro_dme_set		= ufs_qcom_unipro_dme_set,
 	.apply_dev_quirks	= ufs_qcom_apply_dev_quirks,
 	.suspend		= ufs_qcom_suspend,
 	.resume			= ufs_qcom_resume,
diff --git a/drivers/scsi/ufs/ufs-qcom.h b/drivers/scsi/ufs/ufs-qcom.h
index 8208e3a3ef59..83db97caaa1b 100644
--- a/drivers/scsi/ufs/ufs-qcom.h
+++ b/drivers/scsi/ufs/ufs-qcom.h
@@ -124,6 +124,11 @@ enum {
 /* QUniPro Vendor specific attributes */
 #define PA_VS_CONFIG_REG1	0x9000
 #define DME_VS_CORE_CLK_CTRL	0xD002
+
+#define DME_LocalFC0ProtectionTimeOutVal	0xD041
+#define DME_LocalTC0ReplayTimeOutVal		0xD042
+#define DME_LocalAFC0ReqTimeOutVal		0xD043
+
 /* bit and mask definitions for DME_VS_CORE_CLK_CTRL attribute */
 #define DME_VS_CORE_CLK_CTRL_CORE_CLK_DIV_EN_BIT		BIT(8)
 #define DME_VS_CORE_CLK_CTRL_MAX_CORE_CLK_1US_CYCLES_MASK	0xFF
diff --git a/drivers/scsi/ufs/ufshcd.c b/drivers/scsi/ufs/ufshcd.c
index fb32d122f2e3..8ba2ce8c5d0c 100644
--- a/drivers/scsi/ufs/ufshcd.c
+++ b/drivers/scsi/ufs/ufshcd.c
@@ -4231,12 +4231,7 @@ static int ufshcd_change_power_mode(struct ufs_hba *hba,
 	ufshcd_dme_set(hba, UIC_ARG_MIB(PA_PWRMODEUSERDATA5),
 			DL_AFC1ReqTimeOutVal_Default);
 
-	ufshcd_dme_set(hba, UIC_ARG_MIB(DME_LocalFC0ProtectionTimeOutVal),
-			DL_FC0ProtectionTimeOutVal_Default);
-	ufshcd_dme_set(hba, UIC_ARG_MIB(DME_LocalTC0ReplayTimeOutVal),
-			DL_TC0ReplayTimeOutVal_Default);
-	ufshcd_dme_set(hba, UIC_ARG_MIB(DME_LocalAFC0ReqTimeOutVal),
-			DL_AFC0ReqTimeOutVal_Default);
+	ufshcd_vops_unipro_dme_set(hba);
 
 	ret = ufshcd_uic_change_pwr_mode(hba, pwr_mode->pwr_rx << 4
 			| pwr_mode->pwr_tx);
diff --git a/drivers/scsi/ufs/ufshcd.h b/drivers/scsi/ufs/ufshcd.h
index aa9ea3552323..b8c90bee7503 100644
--- a/drivers/scsi/ufs/ufshcd.h
+++ b/drivers/scsi/ufs/ufshcd.h
@@ -311,6 +311,7 @@ struct ufs_pwr_mode_info {
  * @pwr_change_notify: called before and after a power mode change
  *			is carried out to allow vendor spesific capabilities
  *			to be set.
+ * @unipro_dme_set: called when vendor speicific control is needed
  * @setup_xfer_req: called before any transfer request is issued
  *                  to set some things
  * @setup_task_mgmt: called before any task management request is issued
@@ -342,6 +343,7 @@ struct ufs_hba_variant_ops {
 					enum ufs_notify_change_status status,
 					struct ufs_pa_layer_attr *,
 					struct ufs_pa_layer_attr *);
+	void    (*unipro_dme_set)(struct ufs_hba *hba);
 	void	(*setup_xfer_req)(struct ufs_hba *, int, bool);
 	void	(*setup_task_mgmt)(struct ufs_hba *, int, u8);
 	void    (*hibern8_notify)(struct ufs_hba *, enum uic_cmd_dme,
@@ -1161,6 +1163,12 @@ static inline int ufshcd_vops_pwr_change_notify(struct ufs_hba *hba,
 	return -ENOTSUPP;
 }
 
+static inline void ufshcd_vops_unipro_dme_set(struct ufs_hba *hba)
+{
+	if (hba->vops && hba->vops->unipro_dme_set)
+		return hba->vops->unipro_dme_set(hba);
+}
+
 static inline void ufshcd_vops_setup_xfer_req(struct ufs_hba *hba, int tag,
 					bool is_scsi_cmd)
 {
diff --git a/drivers/scsi/ufs/unipro.h b/drivers/scsi/ufs/unipro.h
index 8e9e486a4f7b..224162e5afd8 100644
--- a/drivers/scsi/ufs/unipro.h
+++ b/drivers/scsi/ufs/unipro.h
@@ -192,10 +192,6 @@
 #define DL_TC1ReplayTimeOutVal_Default		65535
 #define DL_AFC1ReqTimeOutVal_Default		32767
 
-#define DME_LocalFC0ProtectionTimeOutVal	0xD041
-#define DME_LocalTC0ReplayTimeOutVal		0xD042
-#define DME_LocalAFC0ReqTimeOutVal		0xD043
-
 /* PA power modes */
 enum {
 	FAST_MODE	= 1,
-- 
2.30.0.478.g8a0d178c01-goog




[Index of Archives]     [Linux ARM Kernel]     [Linux ARM]     [Linux Omap]     [Fedora ARM]     [Linux for Sparc]     [IETF Annouce]     [Security]     [Bugtraq]     [Linux MIPS]     [ECOS]     [Asterisk Internet PBX]     [Linux API]

  Powered by Linux