I would repeat the same commit message that was in commit 5e4b7e82d497
("clk: qcom: gcc-sdm845: Use floor ops for sdcc clks") but it seems
silly to do so when you could just go read that commit.
NOTE: this is actually extra terrible because we're missing the 50 MHz
rate in the table (see the next patch AKA ("clk: qcom: gcc-sc7180: Add
50 MHz clock rate for SDC2")). That means then when you run an older
SD card it'll try to clock it at 100 MHz when it's only specced to run
at 50 MHz max. As you can probably guess that doesn't work super
well.
Signed-off-by: Douglas Anderson <dianders@xxxxxxxxxxxx>
Fixes: 17269568f726 ("clk: qcom: Add Global Clock controller (GCC) driver for SC7180")
---
Taniya: can you please update whatever process is used to generate
these clock files to use floor for SD card clocks. I hope you can
also scour through these files looking for similar problems on other
SoCs and submit patches for them.
drivers/clk/qcom/gcc-sc7180.c | 4 ++--
1 file changed, 2 insertions(+), 2 deletions(-)
diff --git a/drivers/clk/qcom/gcc-sc7180.c b/drivers/clk/qcom/gcc-sc7180.c
index 68d8f7aaf64e..b080739ab0c3 100644
--- a/drivers/clk/qcom/gcc-sc7180.c
+++ b/drivers/clk/qcom/gcc-sc7180.c
@@ -642,7 +642,7 @@ static struct clk_rcg2 gcc_sdcc1_ice_core_clk_src = {
.name = "gcc_sdcc1_ice_core_clk_src",
.parent_data = gcc_parent_data_0,
.num_parents = 4,
- .ops = &clk_rcg2_ops,
+ .ops = &clk_rcg2_floor_ops,
},
};
@@ -666,7 +666,7 @@ static struct clk_rcg2 gcc_sdcc2_apps_clk_src = {
.name = "gcc_sdcc2_apps_clk_src",
.parent_data = gcc_parent_data_5,
.num_parents = 5,
- .ops = &clk_rcg2_ops,
+ .ops = &clk_rcg2_floor_ops,
},
};
--
2.29.2.576.ga3fc446d84-goog
