On 2/4/2019 10:36 AM, Marc Gonzalez wrote:
Add host controller and PHY DT nodes.
Signed-off-by: Marc Gonzalez <marc.w.gonzalez@xxxxxxx>
---
vddp-ref-clk-max-microamp = <100>; sounds tiny and fishy.
Jeffrey, Bjorn, can you check?
The PHY driver doesn't seem to try to set any load...
Yes, 0.1mA matches the hardware documentation.
IMO, this should be the last change in the series, not the first.
Otherwise, seems good.
Reviewed-by: Jeffrey Hugo <jhugo@xxxxxxxxxxxxxx>
---
arch/arm64/boot/dts/qcom/msm8998-mtp.dtsi | 19 +++++++
arch/arm64/boot/dts/qcom/msm8998.dtsi | 63 +++++++++++++++++++++++
2 files changed, 82 insertions(+)
diff --git a/arch/arm64/boot/dts/qcom/msm8998-mtp.dtsi b/arch/arm64/boot/dts/qcom/msm8998-mtp.dtsi
index 50e9033aa7f6..80075283847a 100644
--- a/arch/arm64/boot/dts/qcom/msm8998-mtp.dtsi
+++ b/arch/arm64/boot/dts/qcom/msm8998-mtp.dtsi
@@ -257,3 +257,22 @@
pinctrl-0 = <&sdc2_clk_on &sdc2_cmd_on &sdc2_data_on &sdc2_cd_on>;
pinctrl-1 = <&sdc2_clk_off &sdc2_cmd_off &sdc2_data_off &sdc2_cd_off>;
};
+
+&ufshc {
+ vcc-supply = <&vreg_l20a_2p95>;
+ vccq-supply = <&vreg_l26a_1p2>;
+ vccq2-supply = <&vreg_s4a_1p8>;
+ vcc-max-microamp = <750000>;
+ vccq-max-microamp = <560000>;
+ vccq2-max-microamp = <750000>;
+};
+
+&ufsphy {
+ vdda-phy-supply = <&vreg_l1a_0p875>;
+ vdda-pll-supply = <&vreg_l2a_1p2>;
+ vddp-ref-clk-supply = <&vreg_l26a_1p2>;
+ vdda-phy-max-microamp = <51400>;
+ vdda-pll-max-microamp = <14600>;
+ vddp-ref-clk-max-microamp = <100>;
+ vddp-ref-clk-always-on;
+};
diff --git a/arch/arm64/boot/dts/qcom/msm8998.dtsi b/arch/arm64/boot/dts/qcom/msm8998.dtsi
index 6f4f4b79853b..831af20143da 100644
--- a/arch/arm64/boot/dts/qcom/msm8998.dtsi
+++ b/arch/arm64/boot/dts/qcom/msm8998.dtsi
@@ -711,6 +711,69 @@
redistributor-stride = <0x0 0x20000>;
interrupts = <GIC_PPI 9 IRQ_TYPE_LEVEL_HIGH>;
};
+
+ ufshc: ufshc@1da4000 {
+ compatible = "qcom,msm8998-ufshc", "qcom,ufshc",
+ "jedec,ufs-2.0";
+ reg = <0x01da4000 0x2500>;
+ interrupts = <GIC_SPI 265 IRQ_TYPE_LEVEL_HIGH>;
+ phys = <&ufsphy_lanes>;
+ phy-names = "ufsphy";
+ lanes-per-direction = <2>;
+ power-domains = <&gcc UFS_GDSC>;
+
+ clock-names =
+ "core_clk",
+ "bus_aggr_clk",
+ "iface_clk",
+ "core_clk_unipro",
+ "ref_clk",
+ "tx_lane0_sync_clk",
+ "rx_lane0_sync_clk",
+ "rx_lane1_sync_clk";
+ clocks =
+ <&gcc GCC_UFS_AXI_CLK>,
+ <&gcc GCC_AGGRE1_UFS_AXI_CLK>,
+ <&gcc GCC_UFS_AHB_CLK>,
+ <&gcc GCC_UFS_UNIPRO_CORE_CLK>,
+ <&rpmcc RPM_SMD_LN_BB_CLK1>,
+ <&gcc GCC_UFS_TX_SYMBOL_0_CLK>,
+ <&gcc GCC_UFS_RX_SYMBOL_0_CLK>,
+ <&gcc GCC_UFS_RX_SYMBOL_1_CLK>;
+ freq-table-hz =
+ <50000000 200000000>,
+ <0 0>,
+ <0 0>,
+ <37500000 150000000>,
+ <0 0>,
+ <0 0>,
+ <0 0>,
+ <0 0>;
+
+ resets = <&gcc GCC_UFS_BCR>;
+ reset-names = "rst";
+ };
+
+ ufsphy: phy@1da7000 {
+ compatible = "qcom,msm8998-qmp-ufs-phy";
+ reg = <0x01da7000 0x18c>;
+ #address-cells = <1>;
+ #size-cells = <1>;
+ ranges;
+ clock-names = "ref", "ref_aux";
+ clocks =
+ <&gcc GCC_UFS_CLKREF_CLK>,
+ <&gcc GCC_UFS_PHY_AUX_CLK>;
+
+ ufsphy_lanes: lanes@1da7400 {
+ reg = <0x01da7400 0x128>,
+ <0x01da7600 0x1fc>,
+ <0x01da7c00 0x1dc>,
+ <0x01da7800 0x128>,
+ <0x01da7a00 0x1fc>;
+ #phy-cells = <0>;
+ };
+ };
};
};
--
Jeffrey Hugo
Qualcomm Datacenter Technologies as an affiliate of Qualcomm
Technologies, Inc.
Qualcomm Technologies, Inc. is a member of the
Code Aurora Forum, a Linux Foundation Collaborative Project.