On Fri, Aug 10, 2018 at 10:36 PM Lina Iyer <ilina@xxxxxxxxxxxxxx> wrote: > > On Thu, Aug 09 2018 at 02:16 -0600, Rafael J. Wysocki wrote: > >On Wed, Aug 8, 2018 at 8:02 PM, Lina Iyer <ilina@xxxxxxxxxxxxxx> wrote: > >> On Wed, Aug 08 2018 at 04:56 -0600, Lorenzo Pieralisi wrote: > >>> > >>> On Mon, Aug 06, 2018 at 11:37:55AM +0200, Rafael J. Wysocki wrote: > >>>> > >>>> On Fri, Aug 3, 2018 at 1:42 PM, Ulf Hansson <ulf.hansson@xxxxxxxxxx> > >>>> wrote: > >>>> > [...] > >>>> > > >>>> >>> > >>>> >>> Assuming that I have got that right, there are concerns, mostly > >>>> >>> regarding > >>>> >>> patch [07/26], but I will reply to that directly. > >>>> >> > >>>> >> Well, I haven't got that right, so never mind. > >>>> >> > >>>> >> There are a few minor things to address, but apart from that the > >>>> >> general > >>>> >> genpd patches look ready. > >>>> > > >>>> > Alright, thanks! > >>>> > > >>>> > I will re-spin the series and post a new version once 4.19 rc1 is out. > >>>> > Hopefully we can queue it up early in next cycle to get it tested in > >>>> > next for a while. > >>>> > > >>>> >> > >>>> >>> The $subject patch is fine by me by itself, but it obviously depends > >>>> >>> on the > >>>> >>> previous ones. Patches [01-02/26] are fine too, but they don't seem > >>>> >>> to be > >>>> >>> particularly useful without the rest of the series. > >>>> >>> > >>>> >>> As far as patches [10-26/26] go, I'd like to see some review comments > >>>> >>> and/or > >>>> >>> tags from the people with vested interest in there, in particular > >>>> >>> from Daniel > >>>> >>> on patch [12/26] and from Sudeep on the PSCI ones. > >>>> >> > >>>> >> But this still holds. > >>>> > > >>>> > Actually, patch 10 and patch11 is ready to go as well. I ping Daniel > >>>> > on patch 12. > >>>> > > >>>> > In regards to the rest of the series, some of the PSCI/ARM changes > >>>> > have been reviewed by Mark Rutland, however several changes have not > >>>> > been acked. > >>>> > > >>>> > On the other hand, one can also interpret the long silence in regards > >>>> > to PSCI/ARM changes as they are good to go. :-) > >>>> > >>>> Well, in that case giving an ACK to them should not be an issue for > >>>> the people with a vested interest I suppose. > >>> > >>> > >>> Apologies to everyone for the delay in replying. > >>> > >>> Side note: cpu_pm_enter()/exit() are also called through syscore ops in > >>> s2RAM/IDLE, you know that but I just wanted to mention it to compound > >>> the discussion. > >>> > >>> As for PSCI patches I do not personally think PSCI OSI enablement is > >>> beneficial (and my position has always been the same since PSCI OSI was > >>> added to the specification, I am not even talking about this patchset) > >>> and Arm Trusted Firmware does not currently support it for the same > >>> reason. > >>> > >>> We (if Mark and Sudeep agree) will enable PSCI OSI if and when we have a > >>> definitive and constructive answer to *why* we have to do that that is > >>> not a dogmatic "the kernel knows better" but rather a comprehensive > >>> power benchmark evaluation - I thought that was the agreement reached > >>> at OSPM but apparently I was mistaken. > >>> > >> I will not speak to any comparison of benchmarks between OSI and PC. > >> AFAIK, there are no platforms supporting both. > >> > >> But, the OSI feature is critical for QCOM mobile platforms. The > >> last man activities during cpuidle save quite a lot of power. Powering > >> off the clocks, busses, regulators and even the oscillator is very > >> important to have a reasonable battery life when using the phone. > >> Platform coordinated approach falls quite short of the needs of a > >> powerful processor with a desired battery efficiency. > > > >Even so, you still need firmware (or hardware) to do the right thing > >in the concurrent wakeup via an edge-triggered interrupt case AFAICS. > >That is, you need the domain to be prevented from being turned off if > >one of the CPUs in it has just been woken up and the interrupt is > >still pending. > Yes, that is true and we have been doing this on pretty much every QC > SoC there is, for CPU domains. Generally, there is a handshake of sorts > with the power domain controller when the core executes WFI. It > decrements the reference on the controller when going down and > increments when coming up. The controller is only turned off when the > reference count is 0 and is turned back on before the CPU is ready to > exit the WFI. > > What we are doing here is hand the domain's ->power_off and ->power_on > over to the platform firmware, which needs to make sure the races are > handled correctly either in h/w or through mechanisms like MCPM or in > the firmware. I would consider what happens during the power on/off of > the domains beyond the realm of the genpd at least for CPU specific PM > domains. I see. The dependency on this FW/HW behavior should be clearly documented, though, preferably next to the code in question, or people will try to use it on systems where this requirement is not met and will be wondering what's wrong and/or complaining.
