Add support for TEMP_ALARM LITE PMIC peripherals. This subtype
utilizes a pair of registers to configure a warning interrupt
threshold temperature and an automatic hardware shutdown
threshold temperature.
Signed-off-by: David Collins <david.collins@xxxxxxxxxxxxxxxx>
Signed-off-by: Anjelique Melendez <anjelique.melendez@xxxxxxxxxxxxxxxx>
---
drivers/thermal/qcom/qcom-spmi-temp-alarm.c | 204 +++++++++++++++++++-
1 file changed, 203 insertions(+), 1 deletion(-)
diff --git a/drivers/thermal/qcom/qcom-spmi-temp-alarm.c b/drivers/thermal/qcom/qcom-spmi-temp-alarm.c
index a10f368f2039..081db1a85b8a 100644
--- a/drivers/thermal/qcom/qcom-spmi-temp-alarm.c
+++ b/drivers/thermal/qcom/qcom-spmi-temp-alarm.c
@@ -22,6 +22,7 @@
#define QPNP_TM_REG_TYPE 0x04
#define QPNP_TM_REG_SUBTYPE 0x05
#define QPNP_TM_REG_STATUS 0x08
+#define QPNP_TM_REG_IRQ_STATUS 0x10
#define QPNP_TM_REG_SHUTDOWN_CTRL1 0x40
#define QPNP_TM_REG_ALARM_CTRL 0x46
@@ -29,14 +30,20 @@
#define QPNP_TM_REG_TEMP_DAC_STG1 0x47
#define QPNP_TM_REG_TEMP_DAC_STG2 0x48
#define QPNP_TM_REG_TEMP_DAC_STG3 0x49
+#define QPNP_TM_REG_LITE_TEMP_CFG1 0x50
+#define QPNP_TM_REG_LITE_TEMP_CFG2 0x51
#define QPNP_TM_TYPE 0x09
#define QPNP_TM_SUBTYPE_GEN1 0x08
#define QPNP_TM_SUBTYPE_GEN2 0x09
+#define QPNP_TM_SUBTYPE_LITE 0xC0
#define STATUS_GEN1_STAGE_MASK GENMASK(1, 0)
#define STATUS_GEN2_STATE_MASK GENMASK(6, 4)
+/* IRQ status only needed for TEMP_ALARM_LITE */
+#define IRQ_STATUS_MASK BIT(0)
+
#define SHUTDOWN_CTRL1_OVERRIDE_S2 BIT(6)
#define SHUTDOWN_CTRL1_THRESHOLD_MASK GENMASK(1, 0)
@@ -44,6 +51,8 @@
#define ALARM_CTRL_FORCE_ENABLE BIT(7)
+#define LITE_TEMP_CFG_THRESHOLD_MASK GENMASK(3, 2)
+
#define THRESH_COUNT 4
#define STAGE_COUNT 3
@@ -88,6 +97,19 @@ static const long temp_dac_max[STAGE_COUNT] = {
119375, 159375, 159375
};
+/*
+ * TEMP_ALARM_LITE has two stages: warning and shutdown with independently
+ * configured threshold temperatures.
+ */
+
+static const long temp_lite_warning_map[THRESH_COUNT] = {
+ 115000, 125000, 135000, 145000
+};
+
+static const long temp_lite_shutdown_map[THRESH_COUNT] = {
+ 135000, 145000, 160000, 175000
+};
+
/* Temperature in Milli Celsius reported during stage 0 if no ADC is present */
#define DEFAULT_TEMP 37000
@@ -197,6 +219,24 @@ static int qpnp_tm_gen2_get_temp_stage(struct qpnp_tm_chip *chip)
return alarm_state_map[ret];
}
+/**
+ * qpnp_tm_lite_get_temp_stage() - return over-temperature stage
+ * @chip: Pointer to the qpnp_tm chip
+ *
+ * Return: alarm interrupt state on success, or errno on failure.
+ */
+static int qpnp_tm_lite_get_temp_stage(struct qpnp_tm_chip *chip)
+{
+ u8 reg = 0;
+ int ret;
+
+ ret = qpnp_tm_read(chip, QPNP_TM_REG_IRQ_STATUS, ®);
+ if (ret < 0)
+ return ret;
+
+ return reg & IRQ_STATUS_MASK;
+}
+
/*
* This function updates the internal temp value based on the
* current thermal stage and threshold as well as the previous stage
@@ -376,6 +416,96 @@ static const struct thermal_zone_device_ops qpnp_tm_gen2_rev2_sensor_ops = {
.set_trip_temp = qpnp_tm_gen2_rev2_set_trip_temp,
};
+static int qpnp_tm_lite_set_temp_thresh(struct qpnp_tm_chip *chip, int trip, int temp)
+{
+ int ret, temp_cfg, i;
+ const long *temp_map;
+ u16 addr;
+ u8 reg, thresh;
+
+ if (trip < 0 || trip >= STAGE_COUNT) {
+ dev_err(chip->dev, "invalid TEMP_LITE trip = %d\n", trip);
+ return -EINVAL;
+ }
+
+ switch (trip) {
+ case 0:
+ temp_map = temp_lite_warning_map;
+ addr = QPNP_TM_REG_LITE_TEMP_CFG1;
+ break;
+ case 1:
+ /*
+ * The second trip point is purely in software to facilitate
+ * a controlled shutdown after the warning threshold is crossed
+ * but before the automatic hardware shutdown threshold is
+ * crossed.
+ */
+ return 0;
+ case 2:
+ temp_map = temp_lite_shutdown_map;
+ addr = QPNP_TM_REG_LITE_TEMP_CFG2;
+ break;
+ default:
+ return 0;
+ }
+
+ if (temp < temp_map[THRESH_MIN] || temp > temp_map[THRESH_MAX]) {
+ dev_err(chip->dev, "invalid TEMP_LITE temp = %d\n", temp);
+ return -EINVAL;
+ }
+
+ thresh = 0;
+ temp_cfg = temp_map[thresh];
+ for (i = THRESH_MAX; i >= THRESH_MIN; i--) {
+ if (temp >= temp_map[i]) {
+ thresh = i;
+ temp_cfg = temp_map[i];
+ break;
+ }
+ }
+
+ if (temp_cfg == chip->temp_thresh_map[trip])
+ return 0;
+
+ ret = qpnp_tm_read(chip, addr, ®);
+ if (ret < 0) {
+ dev_err(chip->dev, "LITE_TEMP_CFG read failed, ret=%d\n", ret);
+ return ret;
+ }
+
+ reg &= ~LITE_TEMP_CFG_THRESHOLD_MASK;
+ reg |= FIELD_PREP(LITE_TEMP_CFG_THRESHOLD_MASK, thresh);
+
+ ret = qpnp_tm_write(chip, addr, reg);
+ if (ret < 0) {
+ dev_err(chip->dev, "LITE_TEMP_CFG write failed, ret=%d\n", ret);
+ return ret;
+ }
+
+ chip->temp_thresh_map[trip] = temp_cfg;
+
+ return 0;
+}
+
+static int qpnp_tm_lite_set_trip_temp(struct thermal_zone_device *tz,
+ const struct thermal_trip *trip, int temp)
+{
+ unsigned int trip_index = THERMAL_TRIP_PRIV_TO_INT(trip->priv);
+ struct qpnp_tm_chip *chip = thermal_zone_device_priv(tz);
+ int ret;
+
+ mutex_lock(&chip->lock);
+ ret = qpnp_tm_lite_set_temp_thresh(chip, trip_index, temp);
+ mutex_unlock(&chip->lock);
+
+ return ret;
+}
+
+static const struct thermal_zone_device_ops qpnp_tm_lite_sensor_ops = {
+ .get_temp = qpnp_tm_get_temp,
+ .set_trip_temp = qpnp_tm_lite_set_trip_temp,
+};
+
static irqreturn_t qpnp_tm_isr(int irq, void *data)
{
struct qpnp_tm_chip *chip = data;
@@ -452,6 +582,68 @@ static int qpnp_tm_gen2_rev2_init(struct qpnp_tm_chip *chip)
return 0;
}
+/* Configure TEMP_LITE registers based on DT thermal_zone trips */
+static int qpnp_tm_lite_configure_trip_temps_cb(struct thermal_trip *trip, void *data)
+{
+ struct qpnp_tm_chip *chip = data;
+ int ret;
+
+ trip->priv = THERMAL_INT_TO_TRIP_PRIV(chip->ntrips);
+ ret = qpnp_tm_lite_set_temp_thresh(chip, chip->ntrips, trip->temperature);
+ chip->ntrips++;
+
+ return ret;
+}
+
+static int qpnp_tm_lite_configure_trip_temps(struct qpnp_tm_chip *chip)
+{
+ int ret;
+
+ ret = thermal_zone_for_each_trip(chip->tz_dev, qpnp_tm_lite_configure_trip_temps_cb, chip);
+ if (ret < 0)
+ return ret;
+
+ /* Verify that trips are strictly increasing. */
+ if (chip->temp_thresh_map[2] <= chip->temp_thresh_map[0]) {
+ dev_err(chip->dev, "Threshold 2=%ld <= threshold 0=%ld\n",
+ chip->temp_thresh_map[2], chip->temp_thresh_map[0]);
+ return -EINVAL;
+ }
+
+ return 0;
+}
+
+/* Read the hardware default TEMP_LITE stage threshold temperatures */
+static int qpnp_tm_lite_init(struct qpnp_tm_chip *chip)
+{
+ int ret, thresh;
+ u8 reg = 0;
+
+ /*
+ * Store the warning trip temp in temp_thresh_map[0] and the shutdown trip
+ * temp in temp_thresh_map[2]. The second trip point is purely in software
+ * to facilitate a controlled shutdown after the warning threshold is
+ * crossed but before the automatic hardware shutdown threshold is
+ * crossed. Thus, there is no register to read for the second trip
+ * point.
+ */
+ ret = qpnp_tm_read(chip, QPNP_TM_REG_LITE_TEMP_CFG1, ®);
+ if (ret < 0)
+ return ret;
+
+ thresh = FIELD_GET(LITE_TEMP_CFG_THRESHOLD_MASK, reg);
+ chip->temp_thresh_map[0] = temp_lite_warning_map[thresh];
+
+ ret = qpnp_tm_read(chip, QPNP_TM_REG_LITE_TEMP_CFG2, ®);
+ if (ret < 0)
+ return ret;
+
+ thresh = FIELD_GET(LITE_TEMP_CFG_THRESHOLD_MASK, reg);
+ chip->temp_thresh_map[2] = temp_lite_shutdown_map[thresh];
+
+ return 0;
+}
+
static const struct spmi_temp_alarm_data spmi_temp_alarm_data = {
.ops = &qpnp_tm_sensor_ops,
.temp_map = &temp_map_gen1,
@@ -480,6 +672,13 @@ static const struct spmi_temp_alarm_data spmi_temp_alarm_gen2_rev2_data = {
.get_temp_stage = qpnp_tm_gen2_get_temp_stage,
};
+static const struct spmi_temp_alarm_data spmi_temp_alarm_lite_data = {
+ .ops = &qpnp_tm_lite_sensor_ops,
+ .setup = qpnp_tm_lite_init,
+ .configure_trip_temps = qpnp_tm_lite_configure_trip_temps,
+ .get_temp_stage = qpnp_tm_lite_get_temp_stage,
+};
+
/*
* This function initializes the internal temp value based on only the
* current thermal stage and threshold. Setup threshold control and
@@ -605,7 +804,8 @@ static int qpnp_tm_probe(struct platform_device *pdev)
}
if (type != QPNP_TM_TYPE || (subtype != QPNP_TM_SUBTYPE_GEN1
- && subtype != QPNP_TM_SUBTYPE_GEN2)) {
+ && subtype != QPNP_TM_SUBTYPE_GEN2
+ && subtype != QPNP_TM_SUBTYPE_LITE)) {
dev_err(&pdev->dev, "invalid type 0x%02x or subtype 0x%02x\n",
type, subtype);
return -ENODEV;
@@ -621,6 +821,8 @@ static int qpnp_tm_probe(struct platform_device *pdev)
chip->data = &spmi_temp_alarm_gen2_rev1_data;
else if (subtype == QPNP_TM_SUBTYPE_GEN2)
chip->data = &spmi_temp_alarm_gen2_data;
+ else if (subtype == QPNP_TM_SUBTYPE_LITE)
+ chip->data = &spmi_temp_alarm_lite_data;
else
return -ENODEV;
--
2.34.1
