Add support in the qcom-spmi-temp-alarm driver for the new PMIC TEMP_ALARM peripheral subtypes: GEN2 rev 2 and LITE. The GEN2 rev 2 subtype provides greater flexibility in temperature threshold specification by using an independent register value to configure each of the three thresholds. The LITE subtype utilizes a simplified set of control registers to configure two thresholds: warning and shutdown. While at it refactor the qcom-spmi-temp-alarm driver to limit code reuse and if/else statements when deciphering between TEMP_ALARM peripheral subtypes. Also add support to avoid a potential issue on certain versions of the TEMP_ALARM GEN2 subtype when automatic stage 2 partial shutdown is disabled. This patch series is a continuation of older series from 7/2024 (https://lore.kernel.org/all/20240729231259.2122976-1-quic_amelende@xxxxxxxxxxx/) but current series has been reworked to address the change in thermal framework to update .set_trip_temp() callback function variables (https://lore.kernel.org/all/8392906.T7Z3S40VBb@xxxxxxxxxxxxx/) Anjelique Melendez (3): thermal: qcom-spmi-temp-alarm: Add temp alarm data struct based on HW subtype thermal: qcom-spmi-temp-alarm: add support for GEN2 rev 2 PMIC peripherals thermal: qcom-spmi-temp-alarm: add support for LITE PMIC peripherals David Collins (1): thermal: qcom-spmi-temp-alarm: enable stage 2 shutdown when required drivers/thermal/qcom/qcom-spmi-temp-alarm.c | 515 ++++++++++++++++++-- 1 file changed, 464 insertions(+), 51 deletions(-) -- 2.34.1
